Temperature measurement of mineral melt by means of a high-speed camera
Authors:
- 8 September 2015
- journal article
- Published by Optica Publishing Group in Applied Optics
- Vol. 54 (26) , 7978-7984
Abstract
This paper presents a temperature evaluation method by means of high-speed, visible light digital camera visualization and its application to the mineral wool production process. The proposed method adequately resolves the temperature-related requirements in mineral wool production and significantly improves the spatial and temporal resolution of measured temperature fields. Additionally, it is very cost effective in comparison with other non-contact temperature field measurement methods, such as infrared thermometry. Using the proposed method for temperatures between 800°C and 1500°C, the available temperature measurement range is approximately 300 K with a single temperature calibration point and without the need for camera setting adjustments. In the case of a stationary blackbody, the proposed method is able to produce deviations of less than 5 K from the reference (thermocouple-measured) temperature in a measurement range within 100 K from the calibration temperature. The method was also tested by visualization of rotating melt film in the rock wool production process. The resulting temperature fields are characterized by a very good temporal and spatial resolution (18,700 frames per second at and 8000 frames per second at ).
Keywords
Funding Information
- Faculty of Mechanical Engineering Ljubljana
This publication has 6 references indexed in Scilit:
- Mineral wool melt fiberization on a spinner wheelChemical Engineering Research and Design, 2014
- Digital camera measurements of soot temperature and soot volume fraction in axisymmetric flamesApplied Optics, 2013
- Calibration of Thermal Imagers by Evaluation of the Entire Field-of-ViewInternational Journal of Thermophysics, 2011
- Analysis of Thermal ImagersInternational Journal of Thermophysics, 2011
- ANANALYSIS OF THE LIGAMENT-TYPE DISINTEGRATION OF THIN LIQUID FILM AT THE EDGE OF A ROTATING DISKJOURNAL OF CHEMICAL ENGINEERING OF JAPAN, 1972
- On ligament formation from spinning discs and cupsChemical Engineering Science, 1964