An investigation on thermodynamics and kinetics of η phase formation in Nb-modified iron-nickel base A286 superalloy
Authors:
- 4 December 2020
- journal article
- research article
- Published by EDP Sciences in Metallurgical Research & Technology
- Vol. 118 (1) , 105
Abstract
In this study, precipitation of η phase (Ni3Ti) in conventional and Nb-modified (Nb-A286) A286 superalloys was evaluated at different aging times and temperatures. The TTP curve of the η phase formation was plotted using thermodynamic analyses, kinetics and microstructural studies. Depending on temperature and heat treatment, the η phase precipitated at the grain boundaries or twin sites, as a result of the γ′ phase or matrix austenite transformation. Heat treatment of conventional A286 superalloy and Nb-A286 was performed within a temperature range of 650 to 900 °C for 2 to 30 h. The η phase transformation was evaluated by scanning electron microscope (SEM) which is equipped to energy dispersive X-ray spectroscopy (EDS) and optical microscopy (OM). In the analyses based on thermodynamic calculations, the interaction of the Gibbs free energy of η phase formation and the diffusion activation energy of the elements, especially titanium and niobium, was considered. The microstructural studies showed that increasing the heat treatment time results in increasing the volume fraction of the η phase. By increasing the aging temperature to 840 and 860 °C for conventional A286 superalloy and Nb-A286 superalloy, respectively, the η phase volume fraction increased, however, further increase led to volume fraction decrease. The results of the thermodynamic analyses showed the tip of the TTP diagrams at temperatures of 860 and 820 °C for the A286 and Nb-A286 alloys, respectively. Investigation of kinetics calculations showed that η phase transformation depends on the diffusion of titanium, nickel, and niobium.Keywords
This publication has 37 references indexed in Scilit:
- Effect of ^|^eta; Phase on Mechanical Properties of the Iron-based Superalloy Using Shear Punch TestingISIJ International, 2013
- Atom probe tomography of Ni-base superalloys Allvac 718Plus and Alloy 718Ultramicroscopy, 2011
- Effect of boron addition on hydrogen embrittlement sensitivity in Fe–Ni based alloysMaterials Science and Engineering: A, 2010
- Influence of aging treatment on precipitation behavior of η phase in Ni-Co-Cr alloyJournal of Iron and Steel Research International, 2010
- Transformation of DO24 η-Ni3Ti phase to face-centered cubic austenite during isothermal aging of an Fe–Ni–Ti alloyActa Materialia, 2009
- Influence of ageing heat treatment on alloy A-286 microstructure and stress corrosion cracking behaviour in PWR primary waterJournal of Nuclear Materials, 2007
- High Temperature Creep, Fatigue and Creep/Fatigue Interaction Behavior of γ' Strengthened Austenitic Iron-Base SuperalloyKey Engineering Materials, 2005
- High Temperature Creep, Fatigue and Creep/Fatigue Interaction Behavior of γ' Strengthened Austenitic Iron-Base Superalloy2005
- Fatigue-induced precipitates at grain boundary of Nb-A286 alloy in high temperature low cycle fatigueMaterials Science and Engineering: A, 2000
- Thermodynamics of SolidsJournal of the Electrochemical Society, 1962