Full-Duplex Receiver With Wideband, High-Power RF Self-Interference Cancellation Based on Capacitor Stacking in Switched-Capacitor Delay Lines
- 26 April 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 59 (7) , 2105-2120
Abstract
The self-interference (SI) channels in full-duplex (FD) radios have large nano-second-scale delay spreads, which poses a significant challenge in designing SI cancelers that can emulate the SI channel over wide bandwidths. Passive implementations of high delay lines have a prohibitively large form factor and loss when implemented on silicon, whereas active implementations suffer from noise and linearity penalties. In this work, we leverage time-interleaved multi-path switched-capacitor (SC) circuits to provide large wideband delays with a small form factor and low power (LP) consumption to implement RF and baseband (BB) cancelers in an FD receiver (RX). We utilize capacitor stacking to obtain passive voltage gain to compensate for the loss of these delay elements, thus permitting an increased number of interleaved paths and, hence, a higher delay. Furthermore, to reduce the RX noise figure (NF) penalty due to injecting the cancellation signal into the receiver, we introduce a novel low-noise trans-impedance amplifier (LNTA) architecture, which injects the cancellation signal into RX and also accomplishes finite impulse response (FIR) filter weighting and summation. The FD receiver is implemented in a standard 65-nm CMOS process and operates from 0.1 to 1 GHz. The RF/BB canceler delay cells have real-/complex-valued weighting with delays ranging from 0 to 7.75 ns/0 to 85 ns while consuming 7.4-and 1.9-mW dc power per tap, respectively. These large tunable delays enable 41-/38-dB integrated SI cancellation for 40-/80-MHz bandwidth over 29-dB isolation provided by a CMOS circulator operating at 0.95 GHz. The canceler handles a transmitter (TX) power of up to $+10$ / $+15$ dBm in LP/high-power (HP) modes with 0.8-/2.8-dB RX NF degradation.Keywords
Funding Information
- Defense Advanced Research Projects Agency (DARPA) Signal Processing at RF
- NSF (EEC-2133516, AST-2232455, CNS-2148128, CNS-2128638, AST-2232458)
- Federal Agency and Industry Partners through the NSF Resilient and Intelligent NextG Systems (RINGS) Program
This publication has 41 references indexed in Scilit:
- A 2.4GHz Full-Duplex Transceiver with Broadband (+120MHz), Linearity-Calibrated and Long-Delayed Self-Interference Cancellation2022
- 26.7 An Impedance-Transforming N-Path Filter Offering Passive Voltage Gain2021
- 6.6 Full-Duplex Receiver with Wideband Multi-Domain FIR Cancellation Based on Stacked-Capacitor, N-Path Switched-Capacitor Delay Lines Achieving >54dB SIC Across 80MHz BW and >15dBm TX Power-Handling2021
- Quasielectrostatic Wave Propagation Beyond the Delay-Bandwidth Limit in Switched NetworksPhysical Review X, 2019
- An In-Band Full-Duplex Radio Receiver With a Passive Vector Modulator Downmixer for Self-Interference CancellationIEEE Journal of Solid-State Circuits, 2015
- A Wideband Highly Integrated and Widely Tunable Transceiver for In-Band Full-Duplex CommunicationIEEE Journal of Solid-State Circuits, 2015
- Compact Cascadable g m -C All-Pass True Time Delay Cell With Reduced Delay Variation Over FrequencyIEEE Journal of Solid-State Circuits, 2015
- In-Band Full-Duplex Wireless: Challenges and OpportunitiesIEEE Journal on Selected Areas in Communications, 2014
- Analog/RF Solutions Enabling Compact Full-Duplex RadiosIEEE Journal on Selected Areas in Communications, 2014
- Tunable High-Q N-Path Band-Pass Filters: Modeling and VerificationIEEE Journal of Solid-State Circuits, 2011