Effective thermal properties of an isotactic polypropylene (α‐iPP) injection moulded part by a multiscale approach
Authors:
- 1 December 2017
- journal article
- research article
- Published by Wiley in Materialwissenschaft und Werkstofftechnik
- Vol. 48 (12) , 1213-1219
Abstract
In injection moulding processes, the melt undergoes a complex deformation and cooling history, which results in an inhomogeneous distribution of crystalline superstructures in semi‐crystalline thermoplastics, which significantly influences their final mechanical and thermal properties. In this paper we describe the determination of local effective thermal properties of a moulded part via a multiscale simulation approach. First a macroscopic filling and heat transfer simulation is performed followed by a microstructure evolution calculation on the micro‐scale. Then, the effective thermal properties are derived via a two‐level homogenization scheme. The results show that the effective thermal conductivity is anisotropic and that it varies asymmetrically over the analysed plate sections.Keywords
Funding Information
- German Research Foundation DFG
- collaborative research centre SFB 1120
This publication has 8 references indexed in Scilit:
- Multiscale simulation to predict microstructure dependent effective elastic properties of an injection molded polypropylene componentMechanics of Materials, 2017
- Mesoscale simulation of the solidification process in injection moulded partsJournal of Polymer Engineering, 2015
- Multi-scale thermal simulation of polymer crystallizationInternational Journal of Material Forming, 2014
- Development of an integrative simulation method to predict the microstructural influence on the mechanical behaviour of semi-crystalline thermoplastic partsInternational Journal of Materials Research, 2012
- Anisotropic thermal conductivity in sheared polypropyleneRheologica Acta, 2005
- Homogenization of the thermal properties of transpiration cooled multi-layer platesComputer Methods in Applied Mechanics and Engineering, 2002
- A Direct Observation of the Formation of Nuclei and the Development of Lamellae in Polymer SpherulitesMacromolecules, 1999
- Measurement and Prediction of Anisotropy in Injection Moulded PP ProductsInternational Polymer Processing, 1998