Active Aeroelastic Control Over a Multisurface Wing: Modeling and Wind-Tunnel Testing
- 1 September 2009
- journal article
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 47 (9) , 1995-2010
Abstract
This paper presents the work that has been performed on a wind-tunnel aeroelastic wing model to implement a multisurface modal control system. Wing model realization, the control system, and experimental setup were described briefly here, together with a methodology used to numerically tune the simple control system. Usage of a multiple wind-tunnel test session has been adopted first to perform numerical–experimental correlations and then to optimize control parameters. The entire control system demonstrates the capability to damp the wing bending and torsion modes while still remaining stable within the flight envelopeKeywords
This publication has 18 references indexed in Scilit:
- The SensorCraft Configurations: A Non-Linear AeroServoElastic Challenge for Aviation2005
- Experimental Investigations of a Vibration Suppression System for a Three-surface Aeroelastic Model2005
- An Approach to Induced Drag Reduction and its Experimental Evaluation2004
- Design of the Blended Wing Body Subsonic TransportJournal of Aircraft, 2004
- Adaptive wing and flow control technologyProgress in Aerospace Sciences, 2001
- Active Aeroelastic Wing Flight Research Program: Technical Program and Model Analytical DevelopmentJournal of Aircraft, 2000
- Rolling maneuver load alleviation using active controlsJournal of Aircraft, 1995
- Summary of an Active Flexible Wing programJournal of Aircraft, 1995
- Design for Active Flutter Suppression and Gust Alleviation Using State-Space Aeroelastic ModelingJournal of Aircraft, 1982
- On the use of Pade approximants to represent unsteady aerodynamic loads for arbitrarily small motions of wings1976