Addition of sodium hyaluronate and the effect on performance of the injectable calcium phosphate cement
- 17 March 2009
- journal article
- research article
- Published by Springer Nature in Journal of Materials Science: Materials in Medicine
- Vol. 20 (8) , 1595-1602
Abstract
An injectable calcium phosphate cement (CPC) with porous structure and excellent anti-washout ability was developed in the study. Citric acid and sodium bicarbonate were added into the CPC powder consisting of tetracalcium phosphate (TTCP) and dicalcium phosphate dihydrate (DCPD) to form macro-pores, then different concentrations of sodium hyaluronate (NaHA) solution, as liquid phase, was added into the cement to investigate its effect on CPC’s performance. The prepared CPCs were tested on workability (injectable time and setting time), mechanical strength, as well as anti-washout ability. The experimental results showed that addition of NaHA not only enhanced the anti-washout ability of the CPC dramatically but also improve its other properties. When NaHA concentration was 0.6 wt%, the injectable time elongated to 15.7 ± 0.6 min, the initial and final setting times were respectively shorten to 18.3 ± 1.2 and 58.7 ± 2.1 min, and the compressive strength were increased to 18.78 ± 1.83 MPa. On the other hand, Addition of NaHA showed little effect on porous structure of the CPC and enhanced its bioactivity obviously, which was confirmed by the apatite formation on its surface after immersion in simulated body fluid (SBF). In conclusion, as an in situ shaped injectable biomaterials, the CPC with appropriate addition of NaHA would notably improve its performance and might be used in minimal invasive surgery for bone repair or reconstruction.Keywords
This publication has 34 references indexed in Scilit:
- Osteoconduction and osteoinduction of low-temperature 3D printed bioceramic implantsBiomaterials, 2008
- Energy dispersive X-ray diffraction study of phase development during hardening of calcium phosphate bone cements with addition of chitosanActa Biomaterialia, 2008
- Evaluation of the biocompatibility of calcium phosphate cement/PLGA microparticle compositesJournal of Biomedical Materials Research Part A, 2008
- Introduction of gelatin microspheres into an injectable calcium phosphate cementJournal of Biomedical Materials Research Part A, 2008
- Influence of a novel radiopacifier on the properties of an injectable calcium phosphate cementActa Biomaterialia, 2007
- Strong, macroporous, and in situ-setting calcium phosphate cement-layered structuresBiomaterials, 2007
- Control of crystallinity of hydrated products in a calcium phosphate bone cementJournal of Biomedical Materials Research Part A, 2007
- Influence of anti‐washout agents on the rheological properties and injectability of a calcium phosphate cementJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2006
- Hyaluronan: The Local Solution Conformation Determined by NMR and Computer Modeling is Close to a Contracted Left-handed 4-Fold HelixJournal of Molecular Biology, 2006
- Injectable and rapid‐setting calcium phosphate bone cement with dicalcium phosphate dihydrateJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005