Achieving High Aspect Ratio of Track Length to Width in Molds for Discrete Track Recording Media
Authors:
Open Access
- 1 January 2008
- journal article
- research article
- Published by Wiley in Journal of Nanotechnology
- Vol. 2008 (1)
Abstract
Discrete track media (DTM) fabricated by nanoimprint lithography (NIL) is considered as a potential technology for future hard disk drives (HDD). In the fabrication of a master mold for NIL, patterning the resist tracks with a narrow distribution in the width is the first critical step. This paper reports the challenges involved in the fabrication of high aspect ratio discrete tracks on Polymethylmethacrylate (PMMA) resist by means of electron beam lithography. It was observed that fabrication parameters applied for successful patterning of discrete tracks in nanoscale length were not directly suitable for the patterning of discrete tracks in micron scale. Hence different approaches such as thick layer resist coating, introducing of post exposure baking process, and varying of exposure parameters were used in order to achieve uniform sharp discrete tracks in micron scale length on the resist. The optimal parameters were used to pattern 20 μm long tracks with 70 nm track pitch on the resist.Keywords
This publication has 11 references indexed in Scilit:
- Recording potential of bit-patterned mediaApplied Physics Letters, 2006
- Recording and reversal properties of nanofabricated magnetic islandsIEEE Transactions on Magnetics, 2005
- Performance evaluation of discrete track perpendicular media for high recording densityIEEE Transactions on Magnetics, 2005
- Design of a manufacturable discrete track recording mediumIEEE Transactions on Magnetics, 2005
- Ultimate limits to thermally assisted magnetic recordingJournal of Physics: Condensed Matter, 2005
- Fabrication of Discrete Track Perpendicular Media for High Recording DensityIEEE Transactions on Magnetics, 2004
- Step and flash imprint lithography template characterization, from an etch perspectiveJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2003
- Patterned media: a viable route to 50 Gbit/in/sup 2/ and up for magnetic recording?IEEE Transactions on Magnetics, 1997
- Thermal stability of recorded information at high densitiesIEEE Transactions on Magnetics, 1997
- Investigation of the adhesive strength of PMMA structures on substrates obtained by deep X-ray lithographyMicroelectronic Engineering, 1996