Dynamic Compression Induced Solidification
Open Access
Abstract
This study presents a method for the determination of the dynamic pressure-dependent solidification of polycarbonate (PC) during flow using high pressure capillary rheometer (HPC) measurements. In addition, the pressure-dependent solidification was determined by isothermal pressure-volume-temperature (pvT) measurements under static conditions without shear. Independent of the compression velocity, a linear increase of the solidification pressure with temperature could be determined. Furthermore, the results indicate that the relaxation time at a constant temperature and compression rate can increase to such an extent that the material can no longer follow within the time scale specified by the compression rate. Consequently, the flow through the capillary stops at a specific pressure, with higher compression rates resulting in lower solidification pressures. Consequently, in regard to HPC measurements, it could be shown that the evaluation of the pressure via a pressure hole can lead to measurement errors in the limit range. Since the filling process in injection molding usually takes place under such transient conditions, the results are likely to be relevant for modelling the flow processes of thin-walled and microstructures with high aspect ratios.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (DFG DR 421/22-1)
This publication has 44 references indexed in Scilit:
- Investigation on the Achievable Flow Length in Injection Moulding of Polymeric Materials with Dynamic Mould TemperingThe Scientific World Journal, 2013
- Compression-Induced Solidification: A Novel Processing Technique for Precise Thermoplastic Optical Components with Negligible Internal StressesISRN Optics, 2012
- Measurement of the pressure dependence of viscosity of polymer melts using a back pressure‐regulated capillary rheometerJournal of Applied Polymer Science, 2010
- Pressure and cooling rate‐induced densification of atactic polystyreneJournal of Applied Polymer Science, 2003
- The pressure dependence of the shear and elongational properties of polymer meltsJournal of Non-Newtonian Fluid Mechanics, 1998
- On the pressure dependency of the viscosity of molten polymersPolymer Engineering & Science, 1994
- Isothermal volume relaxation in aged polycarbonate measured by positron annihilation lifetime spectroscopyPolymer Engineering & Science, 1990
- Pressure effects in polymer melt rheologyJournal of Applied Polymer Science, 1990
- Thermal contraction and volume relaxation of amorphous polymersRheologica Acta, 1984
- Flow of polymers with pressure‐dependent viscosity in injection molding diesPolymer Engineering & Science, 1979