Design of Cryogenic SiGe Low-Noise Amplifiers
Authors:
- 12 November 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 55 (11) , 2306-2312
Abstract
This paper describes a method for designing cryogenic silicon-germanium (SiGe) transistor low-noise amplifiers and reports record microwave noise temperature, i.e., 2 K, measured at the module connector interface with a 50-Omega generator. A theory for the relevant noise sources in the transistor is derived from first principles to give the minimum possible noise temperature and optimum generator impedance in terms of dc measured current gain and transconductance. These measured dc quantities are then reported for an IBM SiGe BiCMOS-8HP transistor at temperatures from 295 to 15 K. The measured and modeled noise and gain for both a single-and two-transistor cascode amplifier in the 0.2-3-GHz range are then presented. The noise model is then combined with the transistor equivalent-circuit elements in a circuit simulator and the noise in the frequency range up to 20 GHz is compared with that of a typical InP HEMT.Keywords
This publication has 6 references indexed in Scilit:
- Low-noise 6-8 GHz receiverIEEE Microwave Magazine, 2006
- Half-terahertz operation of SiGe HBTsIEEE Electron Device Letters, 2006
- Accurate High Frequency Noise Modeling in SiGe HBTs.2005
- Cryogenic Operation of Third-Generation, 200-GHz Peak-$f_T$, Silicon–Germanium Heterojunction Bipolar TransistorsIEEE Transactions on Electron Devices, 2005
- 0.1 μm InP HEMT devices and MMICs for cryogenic low noise amplifiers from X-band to W-band2003
- Optimum Noise Performance of Linear AmplifiersProceedings of the IRE, 1958