Critical Cracking Potentials of 26Cr-1 Mo Ferritic Stainless Steels in Boiling 42% LiCl Solution
Authors:
- 1 October 1992
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 48 (10) , 838-845
Abstract
The critical cracking potentials (Ecc) for 26Cr-1Mo ferritic stainless steels (UNS S44627), above which stress corrosion cracking (SCC) does occur, have been measured at constant load in a hot chloride solution. Various factors affecting Ecc are examined to determine the concept of Ecc. Ecc for the low interstitial 26Cr-1Mo alloy (E-Brite†) is shown to be a potential for crack initiation and is determined by the competing rates of generation of new surface by slip-induced film breakdown and repassivation. Ecc for E-Brite is very sensitive to the microstructural conditions developed by prior thermal and mechanical treatments; varying in the range of -485 mV for the mill annealed to -625 mV for the grain coarsened. On the other hand, the minimum potential permitting crack growth is insensitive to these treatments and corresponds to the most active value of Ecc, -625 mV. When strained at a constant strain rate (2.5 x 10-6/s), the critical potential above which E-Brite is susceptible to SCC corresponds to the most active value of Ecc measured at constant load. Thus, it appears that the most active value of Ecc (-625 mV) is a repassivation potential for growing cracks, and Ecc approaches that for crack propagation as a limiting condition.Keywords
This publication has 11 references indexed in Scilit:
- Stress Corrosion Cracking Initiation in Ferritic Stainless Steels in a Chloride EnvironmentCorrosion, 1987
- Stress Corrosion Cracking of Ferritic Stainless Steels in Chloride SolutionsCorrosion, 1981
- The interaction of strain-rate and repassivation rate in stress corrosion crack propagationCorrosion Science, 1980
- The New Fe-Cr-Mo Ferritic Stainless SteelsCorrosion, 1977
- A Quantitative Analysis on the Initiation of Crevice Corrosion of Stainless SteelsTetsu-to-Hagane, 1977
- Effect of temperature on the kinetics of development of pits in stainless steel in 0·5n NaCl + 0· in H2SO4 solutionCorrosion Science, 1972
- A Technical Note: Stress Corrosion Cracking of Austenitic Stainless SteelCorrosion, 1970
- Mechanism of Chloride Stress Corrosion Cracking of Austenitic Stainless SteelsCorrosion, 1969
- Mechanism of Inhibiting Stress Corrosion Cracking of 18-8 Stainless Steel in MgCl[sub 2] by Acetates and NitratesJournal of the Electrochemical Society, 1969
- Effect of Potential and Stress on Time to Failure of Austenitic Stainless Steels in Magnesium Chloride SolutionsCorrosion, 1967