Uniformity Evaluation for the Mechanical Properties of an AlCrN Coating for Tribological Application Using Probe Methods
- 1 September 2020
- journal article
- research article
- Published by Pleiades Publishing Ltd in Journal of Surface Investigation: X-Ray, Synchrotron and Neutron Techniques
- Vol. 14 (5) , 1032-1039
Abstract
The results are presented for studies concerning the microstructure, phase composition and mechanical properties of an Al–Cr–N coating obtained by means of the cathode-arc evaporation of Al70Cr30 alloy. The values of the elastic modulus (E) and microhardness (H) of the coating are determined using the nanoindentation method. The contrasts of the adhesion forces in the Al–Cr–N coating, the friction coefficients and the specific volumetric wear are obtained using atomic-force microscopy.Keywords
This publication has 15 references indexed in Scilit:
- Microstructure of TiAlN and CrAlN coatings and cutting performance of coated silicon nitride inserts in cast iron turningCeramics International, 2014
- Nanosized substructure of heat-treated high-strength cast ironJournal of Engineering Physics and Thermophysics, 2013
- An analysis of macroparticle-related defects on CrCN and CrN coatings in dependence of the substrate bias voltageVacuum, 2012
- Influence of deposition parameters on hard Cr–Al–N coatings deposited by multi-arc ion platingApplied Surface Science, 2012
- Effects of nitrogen pressure and pulse bias voltage on the properties of Cr–N coatings deposited by arc ion platingSurface and Coatings Technology, 2010
- Ion-beam coatings based on Ni and Cr with ultradispersed diamonds—structure and propertiesVacuum, 2005
- Characterisation of chromium nitride films produced by PVD techniquesThin Solid Films, 2001
- Multilayered chromium/chromium nitride coatings for use in pressure die-castingSurface and Coatings Technology, 2001
- Design and evaluation of tribological coatingsWear, 2000
- Coatings tribology—contact mechanisms and surface designTribology International, 1998