Tuning the phase stability of Mo-based TMD monolayers through coupled vacancy defects and lattice strain
Author:
- 15 August 2018
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 6 (35) , 9561-9568
Abstract
Chalcogen vacancies are common in experimentally fabricated transition metal dichalcogenides (TMDs). However, the impact of vacancies on the phase stability of 2D TMDs is not well understood. In this work, we performed theoretical studies to investigate how vacancies affect the phase energetics of Mo-based TMDs (MoS2, MoSe2, and MoTe2). We found that the chalcogen vacancies tend to be clustered in the 2H phase; by contrast, the vacancies in the 1T′ phase prefer to be isolated at low vacancy concentrations and form clustered vacancy lines at high vacancy concentrations. The presence of X vacancies decreases the energy difference between the 2H and 1T′ phases, and the 1T′ phase becomes stabilized against the 2H phase when the number of vacancies exceeds the critical concentration (22% for MoS2, 20% for MoSe2, and 4% for MoTe2). Since the creation of vacancies would cause lattice strain, we also investigated the role of tensile strain, which appears to be critical in decreasing the 2H/1T′ phase energetics. The defect-free MoX2 monolayers would require an equibiaxial tensile strain of 10–15% to make the 1T′ phase energetically preferable. When vacancies are present, the threshold strain needed for the phase change is significantly reduced, which decreases with increasing defect concentration. Our results revealed that vacancies and tensile strain can both decrease the phase energetics between the 2H and 1T′ phases, and the synergistic effect between them effectively improves the possibility of achieving the 2H to 1T′ transition. It is worthy to note that, among the three MoX2 systems, the phase transformation induced by vacancies and/or strain is most easily accessible in MoTe2 due to its small 2H/1T′ energy difference. The 2H-to-1T′ phase transition in MoS2, however, would require either a high concentration of S vacancies or a large lattice strain, and it is practically more likely the combination of both effects that gives rise to the stabilization of the metastable 1T′ phase.Keywords
Funding Information
- Chongqing University (0220001104473)
This publication has 33 references indexed in Scilit:
- Conducting MoS2 Nanosheets as Catalysts for Hydrogen Evolution ReactionNano Letters, 2013
- Spontaneous Ripple Formation in MoS2 Monolayers: Electronic Structure and Transport EffectsAdvanced Materials, 2013
- Enhanced Hydrogen Evolution Catalysis from Chemically Exfoliated Metallic MoS2 NanosheetsJournal of the American Chemical Society, 2013
- The chemistry of two-dimensional layered transition metal dichalcogenide nanosheetsNature Chemistry, 2013
- Electronics and optoelectronics of two-dimensional transition metal dichalcogenidesNature Nanotechnology, 2012
- New Route for Stabilization of 1T-WS2 and MoS2 PhasesThe Journal of Physical Chemistry C, 2011
- Stretching and Breaking of Ultrathin MoS2ACS Nano, 2011
- Generalized Gradient Approximation Made SimplePhysical Review Letters, 1996
- Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis setPhysical Review B, 1996
- Projector augmented-wave methodPhysical Review B, 1994