A Porous Hydrostatic Gas Bearing for Use in Miniature Turbomachinery
Authors:
- 1 January 1971
- journal article
- research article
- Published by Taylor & Francis in A S L E Transactions
- Vol. 14 (2) , 144-155
Abstract
An analytical program was conducted to establish recommended types of gas-lubricated journal bearings for use in miniature cryogenic turbomachinery. Very high rotative speeds, and the limiting damping properties of gas, indicated that fractional frequency whirl is prevalent, and the most difficult problem to overcome. Of the many journal bearing types investigated, the tilting pad hydro-dynamic and porous hydrostatic journal bearings were suited to the application. A novel spring mounted, three shoe, porous hydrostatic bearing is discussed in terms of design and experimental results. A 1/2 inch diameter journal bearing is subjected to loading and speeds to 700 grams and 65,000 rpm, respectively. Excellent performance in terms of load capacity, power loss, and flow are indicated. Orbit motions of the floated bearing with respect to the supported shaft demonstrate desirable stability characteristics for the range of tests.Keywords
This publication has 5 references indexed in Scilit:
- A Qualitative Study of Gas Bearings Operating at High Subsonic and Supersonic Tangential SpeedsJournal of Applied Mechanics, 1971
- Pressure Boundary Layer in a Transient or Steady Gas Film and Mass InteractionJournal of Applied Mechanics, 1970
- Mean Free Path Effect in Spiral-Grooved Thrust BearingsJournal of Lubrication Technology, 1969
- PRODUCTION-SIZE LATHE HYDROSTATIC COMPONENTS1965
- THE INFLUENCE OF THE MOLECULAR MEAN FREE PATH ON THE PERFORMANCE OF HYDRODYNAMIC GAS LUBRICATED BEARINGS. Interim Report1958