Investigations of cooling solutions for three-dimensional (3D) chip stacks
- 1 February 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10652221,p. 25-32
Abstract
Three-dimensional (3D) chip stacks are receiving more attention for system performance enhancements. However, because of the higher circuit density, the cooling of 3D chip stacks gets more challenging. In conventional cooling methods, a heat sink or a micro-channel cooler is located at the top of the chip to dissipate the generated heat in a chip. In this paper, possible cooling methods from the bottom of a silicon interposer and cooling from the peripheral of a silicon interposer were proposed and evaluated. Based on the experimentally obtained thermal resistance of lead-free (SnAg) interconnections, the cooling performances of the above two cooling solutions were investigated by modeling and the requirements were clarified.Keywords
This publication has 9 references indexed in Scilit:
- Thermal Characterization of a Three-Dimensional (3D) Chip StackTransactions of The Japan Institute of Electronics Packaging, 2009
- Thermal resistance measurements of interconnections, for the investigation of the thermal resistance of a three-dimensional (3D) chip stack2009
- 3D chip-stacking technology with through-silicon vias and low-volume lead-free interconnectionsIBM Journal of Research and Development, 2008
- Interlayer cooling potential in vertically integrated packagesMicrosystem Technologies, 2008
- 3D stacking of chips with electrical and microfluidic I/O interconnects2008
- 3D System Integration TechnologiesMRS Proceedings, 2003
- Thermal Conductivity of Intermetallic Compounds with Metallic BondingMATERIALS TRANSACTIONS, 2002
- Future system-on-silicon LSI chipsIEEE Micro, 1998
- Pressure dependence of the thermal and electrical conductivities of the intermetallic compounds AuCu and AuCu3Journal of Physics and Chemistry of Solids, 1988