Polymer and Elastomer Friction in the Thermal Control Regime
Author:
- 1 January 1987
- journal article
- research article
- Published by Taylor & Francis in A S L E Transactions
- Vol. 30 (2) , 149-159
Abstract
It is proposed that as conditions are made more severe in a dry, sliding contact, a regime is eventually initiated in which friction is governed by heat flow. If is suggested that in any given configuration a maximum allowable sulfate temperature can be defined, two alternate closed-form results for friction can be derived. It is suggested that this regime of friction could be relevant to polymers and elastomers due to their low thermal conductivity. The models are compared quantitatively and quantitatively with results in the literature.Keywords
This publication has 25 references indexed in Scilit:
- A Quantitative Theory for the Computation of Tire Friction Under Severe Conditions of SlidingTire Science and Technology, 1986
- The Thermal Control of Friction at High Sliding SpeedsJournal of Tribology, 1986
- The mechanism of friction of iceWear, 1982
- A Good StartNature, 1966
- The friction and deformation properties of irradiated polytetrafluoroethylene (PTFE)Wear, 1965
- Probable interface temperatures of solids in sliding contactWear, 1964
- Visco-Elastic Properties and the Friction of Solids: Friction of Polymers : Influence of Speed and TemperatureNature, 1963
- The temperature of rubbing surfacesWear, 1959
- Surface friction and dynamic mechanical properties of polymersWear, 1959
- Surface Friction in Ballistic PenetrationJournal of Applied Physics, 1955