Low resistance screen-printed Ag contacts to POCl3 emitters with low saturation current density for high efficiency Si solar cells
Authors:
- 1 June 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01608371,p. 003359-003364
Abstract
The silicon (Si) PV industry recognizes the value of phosphorus (P) emitters with low saturation current density (J 0e ) for ability to produce high final cell open circuit voltage (V OC ). However, emitters of such quality, which usually display low surface phosphorus concentration ([P surface ]) are notoriously difficult to contact using traditional screen-printed silver (Ag) thick film pastes. Here, we tailored P emitter profiles via POCl 3 diffusion to create solar cell emitters displaying low J 0e values of 67 - 148 fA/cm 2 and variable electrically active [P surface ] of 0.5E20 - 2.0E20 atoms/cm 3 in order to study the conditions necessary for low resistance contact to such emitters without appreciably deviating from industrial process conditions. Using a screen-printable Ag conductor paste tailored to contact low [P surface ] emitters, we show fill factor (FF) as high as 80% while maintaining V OC as high as 637 mV on tailored emitters with low J 0e . This results in average solar cell efficiencies of 18.6% with a best efficiency of 18.8%. Series resistance (R SERIES ) analysis revealed that contact resistance was the major resistive component dictating final R SERIES and FF. Finally, microstructural SEM analysis of the Ag/Si contact interface suggested that thin interfacial glass films and extensive Ag precipitate/crystallite surface coverage may explain how such high FF can be attained on emitters with low J 0e and low [P surface ].Keywords
This publication has 10 references indexed in Scilit:
- Microstructural comparison of silicon solar cells’ front-side Ag contact and the evolution of current conduction mechanismsJournal of Applied Physics, 2011
- High-Efficiency Large-Area Rear Passivated Silicon Solar Cells With Local Al-BSF and Screen-Printed ContactsIEEE Journal of Photovoltaics, 2011
- Formation of high quality screen-printed contacts to homogeneous high sheet resistance emitters (HHSE)2011
- 19.4%‐efficient large‐area fully screen‐printed silicon solar cellsPhysica Status Solidi (RRL) – Rapid Research Letters, 2011
- Silicon ink selective emitter process: Optimization of selectively diffused regions for short wavelength response2010
- Understanding and Use of IR Belt Furnace for Rapid Thermal Firing of Screen-Printed Contacts to Si Solar CellsIEEE Electron Device Letters, 2010
- Electron microscopy study of front-side Ag contact in crystalline Si solar cellsJournal of Applied Physics, 2009
- Very low recombination phosphorus emitters for high efficiency crystalline silicon solar cellsSemiconductor Science and Technology, 2008
- Determining Components of Series Resistance from Measurements on a Finished Cell2006
- Silver thick-film contacts on highly doped n-type silicon emitters: Structural and electronic properties of the interfaceApplied Physics Letters, 2003