Residual stress measurements on AISI 316L samples manufactured by selective laser melting
Authors:
- Thomas SimsonTSThomas Simson
- Andreas EmmelAEAndreas Emmel
- Anja DwarsADAnja Dwars
- Juliane BöhmJBJuliane Böhm
Top Cited Papers
- 1 October 2017
- journal article
- Published by Elsevier in Additive Manufacturing
- Vol. 17, 183-189
Abstract
No abstract availableThis publication has 9 references indexed in Scilit:
- Observation of keyhole-mode laser melting in laser powder-bed fusion additive manufacturingJournal of Materials Processing Technology, 2014
- Investigation into the effect of process parameters on microstructural and physical properties of 316L stainless steel parts by selective laser meltingThe International Journal of Advanced Manufacturing Technology, 2014
- Densification behavior of gas and water atomized 316L stainless steel powder during selective laser meltingApplied Surface Science, 2010
- Selective laser melting of biocompatible metals for rapid manufacturing of medical partsRapid Prototyping Journal, 2007
- Residual stresses in selective laser sintering and selective laser meltingRapid Prototyping Journal, 2006
- Selective laser melting of iron-based powderJournal of Materials Processing Technology, 2004
- Effects of laser sintering processing parameters on the microstructure and densification of iron powderMaterials Science and Engineering: A, 2003
- Residual stress. Part 1 – Measurement techniquesMaterials Science and Technology, 2001
- Zur zweckmäßigen Definition von EigenspannungenHTM Journal of Heat Treatment and Materials, 1973