A comparative study of flow instability criteria in the processing map of AlFeCoNiMo0.2 high-entropy alloys
Authors:
- 3 October 2022
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine Letters
- Vol. 102 (10) , 348-358
Abstract
High-entropy alloys (HEAs) were studied via hot compression experiments using a Gleeble-3800 thermal simulation tester. The hot deformation behaviour of an AlFeCoNiMo0.2 HEA and the physical significance of the associated parameters were analyzed according to the Prasad, Gegel, Malas, and Murty instability criteria. Processing maps of different instability criteria under different conditions were constructed. The domain corresponding to a temperature range of 1070°C–1150°C with a strain rate range of 0.001–0.1 s−1 and average power dissipation rates of >40% did not feature flow instability; thus, this domain is appropriate for the AlFeCoNiMo0.2 HEA deformation process. Through microstructure analysis, it was determined that the deformation mechanism in the optimal forming region is dynamic recrystallization.Keywords
This publication has 22 references indexed in Scilit:
- Study of hot forging behavior of as-cast Mg–3Al–1Zn–2Ca alloy towards optimization of its hot workabilityMaterials & Design (1980-2015), 2014
- Processing maps and hot workability of Super304H austenitic heat-resistant stainless steelMaterials Science and Engineering: A, 2009
- Identification of flow instabilities in the processing maps of AISI 304 stainless steelJournal of Materials Processing Technology, 2005
- Microstructural development in equiatomic multicomponent alloysMaterials Science and Engineering: A, 2004
- An analysis of hot formability of the 6061+20% Al2O3 composite by means of different stability criteriaMaterials Science and Engineering: A, 2002
- Processing maps for hot working of titanium alloysMaterials Science and Engineering: A, 1998
- Modeling of dynamic material behavior in hot deformation: Forging of Ti-6242Metallurgical Transactions A, 1984
- A new yield function for compressible materialsInternational Journal of Mechanical Sciences, 1984
- On the mechanism of hot deformationActa Metallurgica, 1966
- Effect of Strain Rate Upon Plastic Flow of SteelJournal of Applied Physics, 1944