Isothermal crystallization and melting behaviors of nano TiO2‐modified polypropylene/polyamide 6 blends
Authors:
- 15 May 2012
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 33 (7) , 1054-1063
Abstract
Titanium dioxide (TiO2) nanoparticles were functionalized with toluene‐2,4‐diisocyanate and then polypropylene/polyamide 6/(PP/PA6) blends containing functionalized‐TiO2 were prepared using a twin screw extruder. Isothermal crystallization and melting behavior of the as‐prepared composites were investigated using differential scanning calorimetry and wide‐angle X‐ray diffraction. Isothermal crystallization analysis shows that the TiO2 nanoparticles have two effects on PP/PA6 blends, i.e., it can favor the improvement of crystallization ability and decrease the crystallization rate of PP/PA6 blends. The improvement of crystallization ability is superior over decreasement of crystallization rate of PA6 chains caused by TiO2, therefore PA6 in PP/PA6/TiO2 nanocomposites have higher crystallization rate than that of PA6 in pure PP/PA6 blends, which indicated TiO2 nanoparticles favored the crystallization of PA6. The TiO2 nanoparticles show no effects on the equilibrium melting temperature (T) values of PP phase but decreases the T values of PA6 phase. In addition, the TiO2 nanoparticles did not change the crystalline polymorph of PP/PA6 blends basically; however, favored the formation of β‐PP. POLYM. COMPOS., 2012. © 2012 Society of Plastics EngineersKeywords
Funding Information
- Scientific Research Fund of Hunan Provincial Education Department (11C0512)
- Fund of State Key Laboratory of Powder Metallurgy, People's Republic of China
This publication has 24 references indexed in Scilit:
- Polymorphism in polyamide 6 and polyamide 6/clay nanocomposites molded via water-assisted injection moldingComposites Part B: Engineering, 2012
- Characterization and finite element modeling of montmorillonite/polypropylene nanocompositesMaterials & Design (1980-2015), 2012
- Tuning the functionalization chemistry of polypropylene for polypropylene/clay nanocompositesReactive and Functional Polymers, 2012
- Microstructural correlations to micromechanical properties of polyamide-6/low density polyethylene-grafted-maleic anhydride/nanoclay ternary nanocompositesMaterials & Design (1980-2015), 2012
- Influence of feeding conditions in twin-screw extrusion of PP/MWCNT composites on electrical and mechanical propertiesComposites Science and Technology, 2011
- Novel melt-processable nylon-6/inorganic fullerene-like WS2 nanocomposites: Complex isothermal crystallization kinetics and melting behaviourMaterials Chemistry and Physics, 2011
- Isothermal crystallization and melting behavior of polypropylene/layered double hydroxide nanocompositesThermochimica Acta, 2009
- The Effect of Functionalized-TiO2 on the Mechanical Properties of PP/PA6/Functionalized-TiO2 Nanocomposites Prepared by Reactive Compatibilization TechnologyJournal of Composite Materials, 2009
- Compatibilizing effect of maleated polypropylene on the mechanical properties of injection molded polypropylene/polyamide 6/functionalized-TiO2 nanocompositesComposites Science and Technology, 2009
- Oxygen barrier properties of polypropylene/polyamide 6 blendsJournal of Applied Polymer Science, 1995