Experimental Evaluation of Internal Model Control Scheme on a DC–DC Boost Converter Exhibiting Nonminimum Phase Behavior
Authors:
- 5 January 2017
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 32 (11) , 8880-8891
Abstract
In this work, an internal model controller (IMC) with two-degree-of-freedom has been implemented as a voltage mode controller for the output voltage regulation of a boost-type dc-dc converter that exhibits nonminimum phase behavior due to occurrence of a right-half plane (RHP) zero. The IMC structure provides an alternate parameterization of the conventional feedback controller and is comparatively simple to tune to achieve satisfactory servo and regulatory behavior that are close to the performance limits set by the RHP zero. An internal model controller was designed using a linear model developed in the neighborhood of a nominal operating point for the converter. To assess the efficacy of the IMC scheme, simulation studies and experimental evaluations were carried. In majority of the problems investigated, the IMC was found to perform significantly better than a PID designed using the conventional approach. The responses obtained using the experimental setup were found to match closely with the responses obtained using the nonlinear dynamic model based closed-loop simulations, which corroborated the conclusions reached through the simulations. Thus, the simulation as well as experimental studies indicated that the IMC scheme is ideally suited for controlling a boost-type dc-dc converter exhibiting the nonminimum phase behavior.Keywords
This publication has 25 references indexed in Scilit:
- A Stabilizing Model Predictive Controller for Voltage Regulation of a DC/DC Boost ConverterIEEE Transactions on Control Systems Technology, 2014
- Small-Signal and Signal-Flow-Graph Modeling of Switched Z-Source Impedance NetworkIEEE Power Electronics Letters, 2005
- Model-based current control of AC machines using the internal model control methodIEEE Transactions on Industry Applications, 1998
- On undershoot in SISO systemsIEEE Transactions on Automatic Control, 1994
- Performance limitations of non-minimum phase systems in the servomechanism problemAutomatica, 1993
- Use of leading-edge modulation to transform boost and flyback converters into minimum-phase-zero systemsIEEE Transactions on Power Electronics, 1991
- Internal model control: PID controller designIndustrial & Engineering Chemistry Process Design and Development, 1986
- Right half plane poles and zeros and design tradeoffs in feedback systemsIEEE Transactions on Automatic Control, 1985
- Internal model control. 2. Design procedure for multivariable systemsIndustrial & Engineering Chemistry Process Design and Development, 1985
- Internal model control. A unifying review and some new resultsIndustrial & Engineering Chemistry Process Design and Development, 1982