Electrochemical studies and diffusion kinetics in the Chevrel phase (Mo6S8) for rechargeable Mg batteries
Authors:
- 11 September 2024
- journal article
- research article
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 57 (48) , 485503
Abstract
Based on its availability, cost and stability, rechargeable Mg batteries (RMBs) are potential candidates to fulfill the futuristic demand for high energy density storage devices. However, they are minimally explored due to sluggish Mg ion diffusion in cathode materials. Literature suggests that the Chevrel phase (CP) (Mo6S8) holds promise as a cathode (positive electrode) for RMBs due to its open structure and self-healing properties during cycling. This study reports the electrochemical performance of Mo6S8 (synthesized using cost effective precursors (Cu–Mo–MoS2)) as a cathode for RMBs for the first time. The development of Mo6S8 is a two-step process: (i) synthesis of Cu2Mo6S8 via high energy milling method using Cu, Mo and MoS2 as precursors and (ii) leaching of Cu from Cu2Mo6S8. The morphological and structural characteristics of the developed materials are recorded using x-ray diffraction and field emission scanning electron microscopy. The developed Mo6S8 is cuboid-shaped with a rhombohedral unit cell. To record the electrochemical performance of Mo6S8 as a positive electrode for rechargeable Mg batteries (RMBs), CR2016 type half-cells are fabricated. It is observed that the initial discharge capacity was 89 mA h g−1 at a current density of 25 mA g−1 (1C = 128 mA g−1). Interestingly, the capacity increases from 89 to ≈100 mA h g−1 during 50 cycles which is higher than reported in the literature. The coulombic efficiency (CE) of ≈90% is observed for 100 cycles. Additionally, the over-potential decreases with an increase in cycle number. Importantly, the authors explained the diffusion behavior of Mg ions in Mo6S8 with 0.4 M 2(PhMgCl)-AlCl3/THF (APC) electrolyte via cyclic voltammetry, electrochemical impedance spectroscopy and galvanostatic intermittent titration (GITT) technique. The diffusion coefficients have been calculated and fall in the range of 10−8−10−14 cm2 s−1. Also, the authors explain the effect of outer site activation during cycling on the diffusion kinetics of the materials using the GITT technique. This investigation of diffusion kinetics of Mg ions in Mo6S8 may pave the way for evaluating various CPs as electrode materials for future rechargeable magnesium battery systems.Keywords
This publication has 45 references indexed in Scilit:
- Modeling of Magnesium Intercalation into Chevrel Phase Mo6S8: Report on Improved Cell DesignBatteries & Supercaps, 2023
- Model‐Based Overpotential Deconvolution, Partial Impedance Spectroscopy, and Sensitivity Analysis of a Lithium‐Ion Cell with Blend CathodeEnergy Technology, 2021
- Recent developments on anode materials for magnesium‐ion batteries: a reviewRare Metals, 2020
- A rapid solid-state synthesis of electrochemically active Chevrel phases (Mo6T8; T = S, Se) for rechargeable magnesium batteriesNano Research, 2017
- Connecting the irreversible capacity loss in Li-ion batteries with the electronic insulating properties of solid electrolyte interphase (SEI) componentsJournal of Power Sources, 2016
- Ultra fast elemental synthesis of high yield copper Chevrel phase with high electrochemical performanceJournal of Solid State Chemistry, 2012
- A review on the problems of the solid state ions diffusion in cathodes for rechargeable Mg batteriesJournal of Electroceramics, 2007
- Molten salt synthesis (MSS) of Cu2Mo6S8—New way for large-scale production of Chevrel phasesJournal of Solid State Chemistry, 2006
- Plating of magnesium from organic solventsElectrochimica Acta, 1996
- The magnesium and magnesium amalgam electrodes in aprotic organic solvents a kinetic studyElectrochimica Acta, 1985