Controlling Separation on a Simulated Compressor Blade Using Vortex-Generator Jets
Authors:
- 1 July 2010
- journal article
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Propulsion and Power
- Vol. 26 (4) , 819-827
Abstract
Flow control using vortex-generator jets has been used to control a separating boundary layer on the surface of a flat plate in the presence of a pressure distribution equaling that on the suction surface of a compressor blade. A parametric study has been performed in which the skew angle and jet velocity of steady jets have been varied. In addition to steady blowing, the jets have been pulsed over a range of reduced frequency from 0.5 to 7.0. Steady blowing with a jet velocity greater than the inlet flow velocity was found to delay separation on the surface of the flat plate and reduce the loss coefficient of an equivalent cascade blade by 36%, relative to the unactuated case. This jet velocityisequivalenttoaninjectedmass flowrateof0.13%oftheinletmass flowrate.Withpulsedblowing,thesame loss reduction was achieved over the unactuated case using 40% less mass flow. This loss reduction, however, required a reduced frequency greater than 6.0 and a peak jet velocity equal to 1.5 times the inlet flow velocity. This corresponds to a jet Mach number in a real compressor of 1.125, pulsing at more than 180 kHz.Keywords
This publication has 22 references indexed in Scilit:
- Flow Measurements of Vortex Generator Jets in Separating Boundary LayerJournal of Propulsion and Power, 2006
- Characterization of Steady Blowing for Flow Control in a Hump DiffuserAIAA Journal, 2005
- Effects of Pulsing on a Vortex Generator JetAIAA Journal, 2003
- Flow Control: The FutureJournal of Aircraft, 2001
- Aerodynamic Flow Control over an Unconventional Airfoil Using Synthetic Jet ActuatorsAIAA Journal, 2001
- On vortex generating jetsInternational Journal of Heat and Fluid Flow, 2000
- Effects of Periodic Excitation on Turbulent Flow Separation from a FlapAIAA Journal, 1998
- Delay of airfoil stall by periodic excitationJournal of Aircraft, 1996
- Behavior of the Laterally Injected Jet in Film Cooling: Measurements of Surface Temperature and Velocity/Temperature Field Within the JetJournal of Turbomachinery, 1994
- The 1993 IGTI Scholar Lecture: Loss Mechanisms in TurbomachinesJournal of Turbomachinery, 1993