A Diagnostic System for Air Brakes in Commercial Vehicles
- 6 September 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Transportation Systems
- Vol. 7 (3) , 360-376
Abstract
The safe operation of vehicles on roads depends, among other things, on a properly functioning brake system. Air brake systems are widely used in commercial vehicles such as trucks, tractor-trailers, and buses. In these brake systems, compressed air is used as the energy transmitting medium to actuate the foundation brakes mounted on the axles. In this paper, a model-based diagnostic system for air brakes is presented. This diagnostic system is based on a nonlinear model for predicting the pressure transients in the brake chamber that correlates the brake chamber pressure to the treadle valve (brake application valve) plunger displacement and the pressure of the air supplied to the brake system. Leaks and "out-of-adjustment" of push rods are two prominent defects that affect the performance of the air brake system. Diagnostic schemes that will monitor the brake system for these defects will be presented and corroborated with experimental data obtained from the brake testing facilityKeywords
This publication has 18 references indexed in Scilit:
- Modeling the Pneumatic Subsystem of an S-cam Air Brake SystemJournal of Dynamic Systems, Measurement, and Control, 2004
- Braking Capability Requirements for In-Use Commercial Vehicles - A ChronologySAE International Journal of Advances and Current Practices in Mobility, 2003
- Hybrid Control of a Truck and Trailer Vehicle2002
- A Hybrid Approach to Traction Control2001
- Automotive engine control and hybrid systems: challenges and opportunitiesProceedings of the IEEE, 2000
- Feasibility of Standardized Diagnostic Device for Maintenance and Inspection of Commercial Motor VehiclesTransportation Research Record: Journal of the Transportation Research Board, 1996
- Fault diagnosis in dynamic systems using analytical and knowledge-based redundancyAutomatica, 1990
- Detecting changes in signals and systems—A surveyAutomatica, 1988
- Process fault detection based on modeling and estimation methods—A surveyAutomatica, 1984
- A survey of design methods for failure detection in dynamic systemsAutomatica, 1976