An Exit Burr Model for Drilling of Metals
Authors:
- 1 September 2000
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 123 (4) , 562-566
Abstract
The mechanics of the formation of exit burrs for drilling metals are analyzed. A burr formation model is developed where the material in front of the drill is modeled as an axi-symmetric, circular plate of varying thickness. The drilling thrust forces are distributed as a pressure along the top surface of this plate. The stress state is then calculated. Material removal continues until a failure condition is reached. At the point of failure of the plate the remaining material is bent out to form the burr. The model also includes temperature effects. Experimental verification was conducted on 2024-T351 aluminum and on 7075-T561 aluminum. Two types of drill geometry were considered. The experiments were conducted with feeds from 0.05 to 0.35 mm/rev. The model accurately predicts the experimental data.Keywords
This publication has 6 references indexed in Scilit:
- Burr/Breakout Model Development and Experimental VerificationJournal of Engineering Materials and Technology, 1996
- A Study on Burr Formation MechanismJournal of Engineering Materials and Technology, 1991
- Investigations on reducing burr formation in drillingInternational Journal of Machine Tool Design and Research, 1986
- Deburring precision miniature partsPrecision Engineering, 1979
- The Formation and Properties of Machining BurrsJournal of Engineering for Industry, 1976
- Mechanics of the Metal Cutting Process. I. Orthogonal Cutting and a Type 2 ChipJournal of Applied Physics, 1945