Pan‐milling mixing – a novel approach to forming polymer blends and controlling their morphology
Authors:
- 24 July 2001
- journal article
- research article
- Published by Wiley in Polymer International
- Vol. 50 (9) , 966-972
Abstract
A novel technique (pan‐milling mixing) was developed to control the morphology and thus enhance the mechanical properties of polypropylene/polyamide 6 (PP/PA6) systems. Through pan‐milling at ambient temperature, PP/PA6 pellets of particle size 2–4 mm can be effectively pulverized to well‐mixed micrometre fine powders in the solid state. During pan‐milling of mixtures of PP and PA6, the polymer molecules undergo chain scission and form copolymers that compatibilize the two polymers in situ. By press moulding the finely mixed PP/PA6 powder obtained at a temperature between the melting points of PA6 and PP (for example 200 °C), a blend can be obtained in which the PA6 powder, retained throughout the process in the solid state, is well dispersed in the PP matrix. The mechanical properties of the system are much better than that of PP/PA6 blends prepared by common twin screw extrusion mixing and injection moulding. Tensile strengths of the fine PA6 particle filled PP/PA6 (70/30) blend is 29.3 MPa, which is 6.1 MPa higher than that of a conventionally prepared PP/PA6 blend. The Izod notched impact strength of a fine PA6 particle‐filled PP/PA6 (70/30) blend is 6.34 kJ m−2, which is 1.72 kJ m−2 higher than that of a conventionally prepared PP/PA6 blend. Morphological analysis shows that the domain size of PA6 in the system is much smaller than that of the PP/PA6 blend, and can be controlled by the processing conditions such as temperature.© 2001 Society of Chemical IndustryKeywords
This publication has 14 references indexed in Scilit:
- Novel Strategy for Polymer Blend Compatibilization: Solid-State Shear PulverizationMacromolecules, 1999
- High-Energy Cryogenic Blending and Compatibilizing of Immiscible PolymersAdvanced Materials, 1999
- Reactive Extrusion: Toward NanoblendsMacromolecules, 1999
- Solid-State Shear Pulverization of Plastics: A Green Recycling ProcessPolymer-Plastics Technology and Engineering, 1999
- Reactive compatibilisation of A/(B/C) polymer blends. Part 1. Investigation of the phase morphology development and stabilisationPolymer, 1998
- Strategies for compatibilization of polymer blendsProgress in Polymer Science, 1998
- Interphase and compatibilization of polymer blendsPolymer Engineering & Science, 1996
- Drop Breakup and Coalescence in Polymer Blends: The Effects of Concentration and CompatibilizationMacromolecules, 1995
- Model experiments concerning morphology development during the initial stages of polymer blendingPolymer Bulletin, 1991
- Polymer alloys and blends: Recent advancesThe Canadian Journal of Chemical Engineering, 1991