Modeling and Characterization of CMOS-Fabricated Capacitive Micromachined Ultrasound Transducers
Authors:
- 20 December 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 20 (1) , 104-118
Abstract
This paper describes the fabrication, characterization, and modeling of complementary metal-oxide-semiconductor (CMOS)-compatible capacitive micromachined ultrasound transducers (CMUTs). The transducers are fabricated using the interconnect and dielectric layers from a standard CMOS fabrication process. Unlike previous efforts toward integrating CMUTs with CMOS electronics, this process adds no microelectromechanical systems-related steps to the CMOS process and requires no critical lithography steps after the CMOS process is complete. Efficient computational models of the transducers were produced through the combined use of finite-element analysis and lumped-element modeling. A method for improved computation of the electrostatic coupling and environmental loading is presented without the need for multiple finite-element computations. Through the use of laser Doppler velocimetry, transient impulse response and steady-state frequency sweep tests were performed. These measurements are compared to the results predicted by the models. The performance characteristics were compared experimentally through changes in the applied bias voltage, device diameter, and medium properties (air, vacuum, oil, and water). Sparse clusters of up to 33 elements were tested in transmit mode in a water tank, achieving a center frequency of 3.5 MHz, a fractional bandwidth of 32%-44%, and pressure amplitudes of 181-184 dB re 1 μParms at 15 mm from the transducer on axis.Keywords
This publication has 30 references indexed in Scilit:
- The use of phase codes in ultrasound imaging: SNR gain and bandwidth requirementsApplied Acoustics, 2009
- Electro-physical technique for post-fabrication measurements of CMOS process layer thicknessesJournal of Research of the National Institute of Standards and Technology, 2007
- Integration of trench-isolated through-wafer interconnects with 2d capacitive micromachined ultrasonic transducer arraysSensors and Actuators A: Physical, 2007
- Piezoelectric materials for high frequency medical imaging applications: A reviewJournal of Electroceramics, 2007
- Fabricating capacitive micromachined ultrasonic transducers with wafer-bonding technologyJournal of Microelectromechanical Systems, 2003
- Fabrication and characterization of surface micromachined capacitive ultrasonic immersion transducersJournal of Microelectromechanical Systems, 1999
- Broadband electrostatic acoustic transducer for ultrasonic measurements in liquidsReview of Scientific Instruments, 1979
- An electrostatic transducer for absolute measurement of ultrasonic wave displacement amplitude in liquidsThe Journal of the Acoustical Society of America, 1978
- The Stretched Membrane Electrostatic LoudspeakerThe Journal of the Acoustical Society of America, 1933
- The Sensitivity and Precision of the Electrostatic Transmitter for Measuring Sound IntensitiesPhysical Review B, 1922