Optimization of Corrosion Wear Resistance of the NiCrBSi Laser-Clad Coatings Fabricated on Ti6Al4V
Open Access
Abstract
Ni-based alloy powder (NiCrBSi) was applied to prepare coatings on Ti6Al4V by laser cladding to improve the wear resistance of the latter under corrosion. The scanning speed was found to be an essential parameter that could adjust the microstructure of the coatings. Changes in the microstructures of the coatings with the scanning speed were highlighted, and the relationships between the microstructures and microhardness, fracture toughness, corrosion, and corrosion wear resistance of the coatings were established. Results indicated that the matrix changes from Ti2Ni + TiNi to primary γ(Ni) + eutectics (γ(Ni) + Ni3Ti) with increasing scanning speed. Moreover, reinforcement phases changed from TiB2 + TiC (5 mm∙s−1) to TiB2 + TiC + Cr7C3 (11 mm∙s−1) to TiB2 + TiC + Cr7C3 + CrB (17 mm∙s−1). The average microhardness of the coatings first increased and then decreased, and the corresponding fracture toughness showed the opposite trend. The optimum combination of these properties was observed in the coating prepared at 11 mm∙s−1. This coating demonstrated excellent wear resistance in 3.5 wt.% NaCl solution, as well as a high corrosion potential, a low corrosion current density, and a low current density when the electrode initially entered a comparatively stable corrosion state. Moreover, compared with coatings prepared at other scanning speeds, this coating revealed a higher critical potential for oxidation film destruction. The results of this research collectively show that regulating the microstructures of laser-clad coatings by applying different scanning speeds is a feasible strategy to optimize the wear resistance of the coatings under corrosion.Keywords
Funding Information
- Natural Science Foundation of Shanghai Municipality (20ZR1422200)
- National Natural Science Foundation of China (51471105)
This publication has 46 references indexed in Scilit:
- Microstructure and mechanical properties of Ni-based composite coatings reinforced by in situ synthesized TiB2 + TiC by laser claddingInternational Journal of Minerals, Metallurgy and Materials, 2013
- Effects of Ti and TiC ceramic powder on laser-cladded Ti–6Al–4V in situ intermetallic compositeApplied Surface Science, 2012
- Dilution effects in laser cladding of Ni–Cr–B–Si–C hardfacing alloysMaterials Letters, 2012
- Fabrication of TiC reinforced Ni based coating by laser claddingSurface Engineering, 2012
- Microstructure and tribological properties of laser cladding Fe-based coating on pure Ti substrateTransactions of Nonferrous Metals Society of China, 2012
- Statistical analysis and optimization of process parameters in Ti6Al4V laser cladding using Nd:YAG laserOptics and Lasers in Engineering, 2012
- Evaluation of modulus of elasticity, nano-hardness and fracture toughness of TiB2–TiC–Al2O3 composite coating developed by SHS and laser claddingMaterials Science and Engineering: A, 2011
- Wear behaviors of an (TiB+TiC)/Ti composite coating fabricated on Ti6Al4V by laser claddingThin Solid Films, 2011
- Joining mechanism of Ti/Al dissimilar alloys during laser welding-brazing processJournal of Alloys and Compounds, 2011
- Pilling-Bedworth ratio for oxidation of alloysMaterials Research Innovations, 2000