Influence of microstructure of alloy on the machining performance of micro EDM
Authors:
- J.Z. LiJLJ.Z. Li
- F.H. ShenFSF.H. Shen
- Z.Y. YuZYZ.Y. Yu
- W. NatsuWNW. Natsu
- 1 August 2013
- journal article
- Published by Elsevier in Surface and Coatings Technology
- Vol. 228, S460-S465
Abstract
No abstract availableThis publication has 11 references indexed in Scilit:
- Machining with micro-size single crystalline diamond tools fabricated by a focused ion beamJournal of Micromechanics and Microengineering, 2009
- Critical assessment and numerical comparison of electro-thermal models in EDMJournal of Materials Processing Technology, 2008
- Surface defects during microcuttingInternational Journal of Machine Tools and Manufacture, 2006
- Thermal conductivity bounds for isotropic, porous materialsInternational Journal of Heat and Mass Transfer, 2005
- Study on Factors Determining Limits of Minimum Machinable Size in Micro EDMCIRP Annals, 2005
- Influence of microstructure on surface integrity in turning—part II: the influence of a microstructure of the workpiece material on cutting forcesInternational Journal of Machine Tools and Manufacture, 2003
- State of the Art of MicromachiningCIRP Annals, 2000
- Typical Metrology of Micro-Hole Arrays Made in Stainless Steel Foils by Two-Stage Micro-EDMCIRP Annals, 1999
- Drilling of Deep Microholes by EDMCIRP Annals, 1989
- Wire Electro-Discharge Grinding for Micro-MachiningCIRP Annals, 1985