On the Two-Parameter Characterization of Elastic-Plastic Crack-Front Fields in Surface-Cracked Plates
Author:
- 1 January 1993
- book chapter
- Published by ASTM International
- p. 120-138
Abstract
Plane-strain elastic-plastic crack-tip fields at a constant J and various elastic T-stress levels were obtained in a modified boundary layer (MBL) formulation similar to that of Betegón and Hancock but with a slightly different power law hardening stress-strain law. The analyses were based upon small geometry change formulation and deformation theory plasticity. To verify the two-parameter characterization of elastic-plastic crack-tip fields, three-dimensional (3-D) elastic-plastic finite element (FE) analyses were performed on plates with deep (a/t = 0.60) and shallow (a/t = 0.15) semielliptical surface cracks under both remote tension and bending. Here t is the plate thickness and a is the maximum penetration of the crack through the plate thickness. In topological planes perpendicular to the semielliptical crack fronts, the crack-opening stress fields, normalized by the local J, were compared with the plane-strain MBL predictions based upon the local J and T. In all four cases studied, better than 94% agreement between the 3-D FE solutions and the plane-strain solutions was obtained for loads up to general yielding. This remarkable agreement held throughout all crack-front locations where the stress fields could be resolved accurately. Given the vastly different distributions of J, T, and crack-opening stress profiles along the collective set of respective crack fronts, the elastic T-stress appears to be a tractable, predictive parameter in quantifying elastic-plastic crack-front stress constraint.Keywords
This publication has 19 references indexed in Scilit:
- Evaluation of the elastic T-stress in surface-cracked plates using the line-spring methodInternational Journal of Fracture, 1992
- Determination of elastic T-stress along three-dimensional crack fronts using an interaction integralInternational Journal of Solids and Structures, 1992
- J-Dominance of short cracks in tension and bendingJournal of the Mechanics and Physics of Solids, 1991
- Crack tip and associated domain integrals from momentum and energy balanceEngineering Fracture Mechanics, 1987
- J-dominance under plane strain fully plastic conditions: the edge crack panel subject to combined tension and bendingInternational Journal of Fracture, 1985
- A comparison of methods for calculating energy release ratesEngineering Fracture Mechanics, 1985
- Requirements for a one parameter characterization of crack tip fields by the HRR singularityInternational Journal of Fracture, 1981
- Influence of non-singular stress terms and specimen geometry on small-scale yielding at crack tips in elastic-plastic materialsJournal of the Mechanics and Physics of Solids, 1973
- Singular behaviour at the end of a tensile crack in a hardening materialJournal of the Mechanics and Physics of Solids, 1968
- Plane strain deformation near a crack tip in a power-law hardening materialJournal of the Mechanics and Physics of Solids, 1968