Enhanced solar performance of chemical bath deposited-Zn(O,S)/Cu(In,Ga)Se 2 solar cells via interface engineering by a wet soaking process
- 10 June 2015
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 3 (29) , 14985-14990
Abstract
A facile wet soaking process by immersing a CIGS thin film in a mixed aqueous solution, containing gallium trichloride and thioacetamide at 80 °C for a few tens of seconds, was proposed to reduce the existence of defects in the CIGS absorption layer which can be confirmed by the temperature dependence of the open-circuit voltage (Voc). The depth profiles of X-ray photoelectron spectroscopy (XPS) results indicate that the gallium (Ga) concentration increases during the short wet soaking time, resulting in a widening of the band gap near the surface region. The enhanced carrier lifetime attributed to the Ga-induced defect reduction during thermal treatment of device fabrication was evaluated by time-resolved photoluminescence (TRPL) spectroscopy. With wet and light soaking processes, Voc, short circuit current (Jsc) and fill factor (F.F.) can be increased, yielding a significant enhancement in cell efficiency from ∼1% to ∼6.4%. We believe that this fast, simple and effective method can further stimulate the development of CBD-Zn(O,S)/post-selenization CIGS solar cells toward commercialized thin film photovoltaics.Keywords
This publication has 23 references indexed in Scilit:
- Another route to fabricate single-phase chalcogenides by post-selenization of Cu–In–Ga precursors sputter deposited from a single ternary targetSolar Energy Materials and Solar Cells, 2009
- Flexible Solar CellsChemSusChem, 2008
- Solar Energy Conversion Toward 1 TerawattMRS Bulletin, 2008
- Incongruent reaction of Cu–(InGa) intermetallic precursors in H2Se and H2SJournal of Applied Physics, 2007
- Low-cost CIGS solar cells by paste coating and selenizationThin Solid Films, 2005
- Buffer layers in Cu(In,Ga)Se2 solar cells and modulesThin Solid Films, 2005
- Influence of Cu(In,Ga)Se2 band gap on the valence band offset with CdSThin Solid Films, 2004
- Chemical bath deposition of Cds buffer layer for GIGS solar cellsSolar Energy Materials and Solar Cells, 1998
- Application of Zn-Compound Buffer Layer for Polycrystalline CuInSe2-Based Thin-Film Solar CellsJapanese Journal of Applied Physics, 1996
- Effect of UV irradiation on evaporated ZnS filmsApplied Optics, 1980