Numerical Investigation of Partial Blockage Effect on Film Cooling Effectiveness
Authors:
Open Access
- 1 January 2014
- journal article
- research article
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2014 (1)
Abstract
Three‐dimensional numerical calculation was performed to investigate the effects of partial blockage inside cylindrical film holes on the film cooling effectiveness over a flat plate. Five blockage ratios ranged from 0.1 to 0.5 and a series of blockage positions were considered under the blowing ratios of 0.3–1.5. It is found that the blockage position has a significant influence on mainstream‐coolant jet interaction. The partial blockage located at the leading edge of coolant‐hole exit mitigates the primary vortices due to mainstream‐coolant jet interaction. The coolant jet penetration along vertical direction is suppressed and the peak velocity along streamwise direction is augmented under the action of partial blockage at the upstream side of film holes, providing an increment of film cooling effectiveness, especially under high blowing ratio. While the partial blockages located at the trailing or lateral edges of coolant‐hole exit weaken the film cooling effectiveness. In relation to the partial blockage located in the vicinity of coolant‐hole exit, the partial blockage located in the vicinity of coolant‐hole inlet or middle has less impaction on the film cooling effectiveness under low blowing ratio.Keywords
Funding Information
- National Natural Science Foundation of China (51276090)
This publication has 22 references indexed in Scilit:
- Numerical study of film cooling from converging slot-hole on a gas turbine blade suction sideInternational Communications in Heat and Mass Transfer, 2014
- Film cooling on a gas turbine blade suction side with converging slot-holeInternational Journal of Thermal Sciences, 2013
- Investigation on film cooling characteristics from a row of converging slot-holes on flat plateScience China Technological Sciences, 2011
- Effects of Surface Deposition, Hole Blockage, and Thermal Barrier Coating Spallation on Vane Endwall Film CoolingJournal of Turbomachinery, 2006
- Effect of Hole Geometry on the Thermal Performance of Fan-Shaped Film Cooling HolesJournal of Turbomachinery, 2005
- A Review of Shaped Hole Turbine Film-Cooling TechnologyJournal of Heat Transfer, 2005
- Improved film cooling from cylindrical angled holes with triangular tabs: effect of tab orientationsInternational Journal of Heat and Fluid Flow, 2003
- Flowfield Measurements for Film-Cooling Holes With Expanded ExitsJournal of Turbomachinery, 1998
- Film Effectiveness Over a Flat Surface With Air and CO2 Injection Through Compound Angle Holes Using a Transient Liquid Crystal Image MethodJournal of Turbomachinery, 1997
- Deposition of Volcanic Materials in the Hot Sections of Two Gas Turbine EnginesJournal of Engineering for Gas Turbines and Power, 1993