Optimization towards high density quantum dots for intermediate band solar cells grown by molecular beam epitaxy
Authors:
- 8 February 2010
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 96 (6) , 061913
Abstract
We report high density quantum dots (QDs) formation with optimized growth temperature and V/III ratio. At lower growth temperature, QD density is increased, due to smaller surface migration length of In adatoms. With higher V/III, the QD density is higher but it results in large clusters formation and decreases the QD uniformity. The QD solar cell was fabricated and examined. An extended spectral response in contrast to the GaAs reference cell was presented but the external quantum efficiency at energies higher than GaAs band gap is reduced, resulting from the degradation for the emitter above the strained QD layers.Keywords
This publication has 9 references indexed in Scilit:
- The Intermediate Band Solar Cell: Progress Toward the Realization of an Attractive ConceptAdvanced Materials, 2009
- AlGaAs/GaAs photovoltaic cells with an array of InGaAs QDsSemiconductors, 2009
- Carrier recombination effects in strain compensated quantum dot stacks embedded in solar cellsApplied Physics Letters, 2008
- Strain-compensated InAs/GaNAs quantum dots for use in high-efficiency solar cellsApplied Physics Letters, 2008
- Limiting efficiency of an intermediate band solar cell under a terrestrial spectrumApplied Physics Letters, 2008
- Emitter degradation in quantum dot intermediate band solar cellsApplied Physics Letters, 2007
- Ga Sb ∕ Ga As type II quantum dot solar cells for enhanced infrared spectral responseApplied Physics Letters, 2007
- General equivalent circuit for intermediate band devices: Potentials, currents and electroluminescenceJournal of Applied Physics, 2004
- Increasing the Efficiency of Ideal Solar Cells by Photon Induced Transitions at Intermediate LevelsPhysical Review Letters, 1997