Finite element analysis of clamping form in wire and arc additive manufacturing
Authors:
- 1 April 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Abstract
A reasonable clamping form can effectively reduce the distortion and defect in wire and arc additive manufacturing. In this paper, a three-dimensional finite element model with verified weld-bead profile and heat source model is established. Using the Simufact.welding finite element analysis software, four typical clamping forms are compared in total distortion and residual stress distribution. The results demonstrate that the edge clamping form has the better performance than the corner clamping form. In edge clamping form, the transversal clamping plays the dominant role than the longitudinal clamping in guaranteeing the dimensional precision. Basing on the analysis of residual stress distribution, the clamping form with only the transversal clamping can obtain the least residual stress distribution.Keywords
This publication has 12 references indexed in Scilit:
- Bead modelling and implementation of adaptive MAT path in wire and arc additive manufacturingRobotics and Computer-Integrated Manufacturing, 2016
- Wire-feed additive manufacturing of metal components: technologies, developments and future interestsThe International Journal of Advanced Manufacturing Technology, 2015
- Development of a Direct Correlation of Bead Geometry, Grain Size and HAZ Width with the GMAW Process Parameters on Bead-on-plate Welds of Mild SteelTransactions of the Indian Institute of Metals, 2015
- Residual stress modeling of narrow gap welded joint of aluminum alloy by cold metal transferring procedureConstruction and Building Materials, 2014
- Modeling of bead section profile and overlapping beads with experimental validation for robotic GMAW-based rapid manufacturingRobotics and Computer-Integrated Manufacturing, 2013
- Thermo-mechanical analysis of Wire and Arc Additive Layer Manufacturing process on large multi-layer partsComputational Materials Science, 2011
- Overlapping model of beads and curve fitting of bead section for rapid manufacturing by robotic MAG welding processRobotics and Computer-Integrated Manufacturing, 2011
- Finite element prediction of thermal stresses and deformations in layered manufacturing of metallic partsActa Mechanica, 2006
- Deformation modelling in layered manufacturing of metallic parts using gas metal arc welding: effect of process parametersModelling and Simulation in Materials Science and Engineering, 2005
- A new finite element model for welding heat sourcesMetallurgical Transactions B, 1984