Preparation and Characterization of Cellulose Acetate Film Reinforced with Cellulose Nanofibril
Open Access
Abstract
In this study, cellulose acetate (CA)/cellulose nanofibril (CNF) film was prepared via solvent casting. CNF was used as reinforcement to increase tensile properties of CA film. CNF ratio was varied into 3, 5, and 10 phr (parts per hundred rubbers). Triacetin (TA) and triethyl citrate (TC) were used as two different eco-friendly plasticizers. Two different types of solvent, which are acetone and N-methyl-2-pyrrolidone (NMP), were also used. CA/CNF film was prepared by mixing CA and CNF in acetone or NMP with 10% concentration and stirred for 24 h. Then, the solution was cast in a polytetrafluoroethylene (PTFE) dish followed by solvent evaporation for 12 h at room temperature for acetone and 24 h at 80 °C in an oven dryer for NMP. The effect of solvent type, plasticizers type, and CNF amount on film properties was studied. Good dispersion in NMP was evident from the morphological study of fractured surface and visible light transmittance. The results showed that CNF has a better dispersion in NMP which leads to a significant increase in tensile strength and elastic modulus up to 38% and 65%, respectively, compared with those of neat CA. CNF addition up to 5 phr loading increased the mechanical properties of the film composites.Keywords
Funding Information
- National Research Foundation of Korea (2021R1A2C2004941, 2018R1A6A1A03025582)
This publication has 31 references indexed in Scilit:
- Recent advances in cellulose and chitosan based membranes for water purification: A concise reviewCarbohydrate Polymers, 2016
- Review of the recent developments in cellulose nanocomposite processingComposites Part A: Applied Science and Manufacturing, 2016
- Cellulose Acetate Blends - Effect of Plasticizers on Properties and BiodegradabilityJournal of Renewable Materials, 2014
- “Green” biocomposites based on cellulose diacetate and regenerated cellulose microfibers: Effect of plasticizer content on morphology and mechanical propertiesComposites Part A: Applied Science and Manufacturing, 2012
- Nanocellulose Reinforced Chitosan Composite Films as Affected by Nanofiller Loading and Plasticizer ContentJournal of Food Science, 2010
- Microfibrillated cellulose/cellulose acetate composites: Effect of surface treatmentJournal of Polymer Science Part B: Polymer Physics, 2009
- Preparation of Homogeneous Dispersions of Tunicate Cellulose Whiskers in Organic SolventsBiomacromolecules, 2007
- Dispersion of cellulose nanocrystals in polar organic solventsCellulose, 2006
- “Green” Nanocomposites from Cellulose Acetate Bioplastic and Clay: Effect of Eco-Friendly Triethyl Citrate PlasticizerBiomacromolecules, 2004
- Plasticization of cellulose diacetate by reaction with maleic anhydride, glycerol, and citrate esters during melt processingJournal of Applied Polymer Science, 2001