Novel Cost-Effective Microfluidic Chip Based on Hybrid Fabrication and Its Comprehensive Characterization
Open Access
Abstract
Microfluidics, one of the most attractive and fastest developed areas of modern science and technology, has found a number of applications in medicine, biology and chemistry. To address advanced designing challenges of the microfluidic devices, the research is mainly focused on development of efficient, low-cost and rapid fabrication technology with the wide range of applications. For the first time, this paper presents fabrication of microfluidic chips using hybrid fabrication technology—a grouping of the PVC (polyvinyl chloride) foils and the LTCC (Low Temperature Co-fired Ceramics) Ceram Tape using a combination of a cost-effective xurography technique and a laser micromachining process. Optical and dielectric properties were determined for the fabricated microfluidic chips. A mechanical characterization of the Ceram Tape, as a middle layer in its non-baked condition, has been performed and Young’s modulus and hardness were determined. The obtained results confirm a good potential of the proposed technology for rapid fabrication of low-cost microfluidic chips with high reliability and reproducibility. The conducted microfluidic tests demonstrated that presented microfluidic chips can resist 3000 times higher flow rates than the chips manufactured using standard xurography technique.Keywords
This publication has 32 references indexed in Scilit:
- Fabricating smooth PDMS microfluidic channels from low-resolution 3D printed molds using an omniphobic lubricant-infused coatingAnalytica Chimica Acta, 2018
- Soft tubular microfluidics for 2D and 3D applicationsProceedings of the National Academy of Sciences, 2017
- The Deformation of Polydimethylsiloxane (PDMS) Microfluidic Channels Filled with Embedded Circular Obstacles under Certain CircumstancesMolecules, 2016
- 3-D LTCC microfluidic device as a tool for studying nanoprecipitationJournal of Physics: Conference Series, 2013
- Commercialization of microfluidic point-of-care diagnostic devicesLab on a Chip, 2012
- Simple and low-cost fabrication of PDMS microfluidic round channels by surface-wetting parameters optimizationMicrofluidics and Nanofluidics, 2011
- Thermoplastic elastomers for microfluidics: Towards a high-throughput fabrication method of multilayered microfluidic devicesLab on a Chip, 2011
- Fully integrated PDMS/SU‐8/quartz microfluidic chip with a novel macroporous poly dimethylsiloxane (PDMS) membrane for isoelectric focusing of proteins using whole‐channel imaging detectionElectrophoresis, 2010
- Reconstituting Organ-Level Lung Functions on a ChipScience, 2010
- Serpentine microfluidic mixer made in LTCCSensors and Actuators B: Chemical, 2009