Evolution Behavior and Closure Mechanism of Porosity in Large Billet during the Reduction Pretreatment
Open Access
Abstract
The reduction pretreatment process was proposed to be applied to large billets for the purpose of alleviating the center porosities and reducing the rolling ratio. This study focused on the evolution behavior and closure mechanism of porosity in a large billet during reduction pretreatment. The porosities were characterized by ultrasonic scanning and 3D reconstruction. The results showed that the porosities near the surface of the billet were firstly closed during the reduction pretreatment. The reduction began to effectively act on the center of the billet at the deformation of 0.16. When the reduction amount increased to 0.20–0.22, both the pore number and the porosity degree at the center of the billet were the smallest. As the deformation exceeded 0.25, the porosities gathered at the center of the billet, which may have caused larger defects. A numerical model for the reduction pretreatment was established to analyze the evolution behavior of porosity. The simulation results showed that the position with the maximum of strain moved toward the center of the billet as the reduction amount increased. At the position where the deformation was 0.20, the deformation would readily occur at the center, and the center strain was almost twice as much as the surface strain. The upper and lower surfaces of porosity were compressed to the center of the porosity in the thickness direction. The two ends of porosity were not stretched in the rolling direction. The closure index indicated that the deformation penetrated into the center would accelerate the deformation of porosity. The cross-sectional area of the porosity gradually decreased with the increase in the hydrostatic integration, which indicated that the hydrostatic integration could be used to assess the closure degree of porosity during the reduction pretreatment process. Both the closure index and the hydrostatic integration proved the effective role of the reduction pretreatment in the alleviation of porosity.Keywords
Funding Information
- National Key Research and Development Program of China (2021YFE0113200)
This publication has 22 references indexed in Scilit:
- Three-dimensional (3D) microstructural characterization and quantification of reflow porosity in Sn-rich alloy/copper joints by X-ray tomographyMaterials Characterization, 2011
- Internal void closure during the forging of large cast ingots using a simulation approachJournal of Materials Processing Technology, 2011
- Development of New Continuous Casting Technology (PCCS) for Very Thick PlateMateria Japan, 2009
- Formation of internal cracks in steel billets during soft reductionJournal of University of Science and Technology Beijing, Mineral, Metallurgy, Material, 2008
- Dynamic Soft Reduction for Continuously Cast Rail BloomJournal of Iron and Steel Research International, 2007
- Modelling of three-dimensional temperature field inside the mould during continuous casting of steelJournal of Materials Processing Technology, 2004
- Experimental study of porosity and its relation to fatigue mechanisms of model Al–Si7–Mg0.3 cast Al alloysMaterials Science and Engineering: A, 2001
- Approximate analysis of roll force in a round–oval–round pass rolling sequenceJournal of Materials Processing Technology, 2001
- Fatigue life assessment of aluminum alloys with casting defectsEngineering Fracture Mechanics, 1993
- Fatigue strength and applications of cast aluminium alloys with different degrees of porosityInternational Journal of Fatigue, 1993