An Assessment of Quantitative Predictions of Deterministic Mixed Lubrication Solvers
- 28 July 2020
- journal article
- research article
- Published by ASME International in Journal of Tribology
- Vol. 143 (1)
Abstract
The ability to simulate mixed lubrication problems has greatly improved, especially in concentrated lubricated contacts. A mixed lubrication simulation method was developed by utilizing the semi-system approach which has been proven to be highly useful for improving stability and robustness of mixed lubrication simulations. Then different variants of the model were developed by varying the discretization schemes used to treat the Couette flow terms in the Reynolds equation, varying the evaluation of density derivatives and varying the contribution of terms in the coefficient matrix. The resulting pressure distribution, film thickness distribution, lambda ratio, contact ratio, and the computation time were compared and found to be strongly influenced by the choice of solution scheme. This indicates that the output from mixed lubrication solvers can be readily used for qualitative and parametric studies, but care should be taken when making quantitative predictions.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/001766/1, EP/S030476/1)
- National Key Research and Development Program of China (2015CB057303)
- National Natural Science Foundation of China (51975315)
This publication has 23 references indexed in Scilit:
- Elastohydrodynamic Lubrication: A Gateway to Interfacial Mechanics—Review and ProspectJournal of Tribology, 2011
- Solution agreement between dry contacts and lubrication system at ultra-low speedProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2010
- A Three-Dimensional Deterministic Model for Rough Surface Line-Contact EHL ProblemsJournal of Tribology, 2008
- A Full Numerical Solution to the Mixed Lubrication in Point ContactsJournal of Tribology, 1999
- Point Contact EHL Based on Optically Measured Three-Dimensional Rough SurfacesJournal of Tribology, 1997
- On the Numerical Determination of Flow FactorsJournal of Tribology, 1997
- Numerical Analysis of the Influence of Waviness on the Film Thickness of a Circular EHL ContactJournal of Tribology, 1996
- The Effects of Surface Irregularities on the Elastohydrodynamic Lubrication of Sliding Line Contacts. Part II—Wavy SurfacesJournal of Tribology, 1984
- The Effects of Surface Irregularities on the Elastohydrodynamic Lubrication of Sliding Line Contacts. Part I—Single IrregularitiesJournal of Tribology, 1984
- An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic LubricationJournal of Lubrication Technology, 1978