Demodulation phase angle compensation for quadrature error in decoupled dual-mass MEMS gyroscope
- 10 July 2018
- journal article
- research article
- Published by SPIE-Intl Soc Optical Eng in Journal of Micro/Nanolithography, MEMS, and MOEMS
- Vol. 17 (03) , 035001-13
Abstract
This paper proposes a demodulation phase angle compensation (DPAC) for dual-mass MEMS gyroscopes with small frequency split (Δω) and low-quality factor (Q value), to reduce the quadrature interference on Coriolis signal output. The harmful contribution of quadrature error and demodulation phase angle drift to the gyroscope performances is analyzed and quantified. The quadrature stiffness correction (QSC) system based on DPAC is redesigned, and it was analyzed that the QSC would reduce the Δω and then affect the performances of the gyroscope. Wherein, the DPAC algorithm is implemented by a back propagation neural network. Finally, the experiments are arranged to verify the theoretical analysis. DPAC experiments were performed for both open-loop detection method and QSC method, respectively, for open-loop detection without DPAC (test 1), open-loop detection with DPAC (test 2), QSC without DPAC (test 3), and QSC with DPAC (test 4). The scale factor results based on these four tests are 15.384, 15.441, 16.652, and 16.731 mV / deg / s, respectively. When tests 2, 3, and 4 are compared to test 1, the bias stability results improved by 88%, 84%, and 97%, and the angle random walk improved by 28%, 23%, and 34%, respectively. Test 4 is proved to be the best type for bias performances, as is the case with a temperature range experiment from 60°C to −40 ° C, but the performances of its scale factor deteriorated. Moreover, the bandwidth is reduced by 4 Hz because of the QSC.Keywords
This publication has 19 references indexed in Scilit:
- Investigating the effects of quadrature error in parametrically and harmonically excited MEMS rate gyroscopesMeasurement, 2016
- Temperature drift modeling of MEMS gyroscope based on genetic-Elman neural networkMechanical Systems and Signal Processing, 2016
- Mechanical Coupling Error Suppression Technology for an Improved Decoupled Dual-Mass Micro-GyroscopeSensors, 2016
- Digital Control System for the MEMS Tuning Fork Gyroscope Based on Synchronous Integral DemodulatorIEEE Sensors Journal, 2015
- Analysis of Frequency Response and Scale-Factor of Tuning Fork Micro-Gyroscope Operating at Atmospheric PressureSensors, 2015
- A MEMS Vibratory Gyroscope With Real-Time Mode-Matching and Robust Control for the Sense ModeIEEE Sensors Journal, 2014
- Design and Application of Quadrature Compensation Patterns in Bulk Silicon Micro-GyroscopesSensors, 2014
- Electrostatic stiffness correction for quadrature error in decoupled dual-mass MEMS gyroscopeJournal of Micro/Nanolithography, MEMS, and MOEMS, 2014
- Two Novel Measurements for the Drive-Mode Resonant Frequency of a Micromachined Vibratory GyroscopeSensors, 2013
- Improvement of bias stability for a micromachined gyroscope based on dynamic electrical balancing of coupling stiffnessJournal of Micro/Nanolithography, MEMS, and MOEMS, 2013