Materials, properties, manufacturing methods and cutting performance of innovative ceramic cutting tools − a review
Open Access
- 14 June 2019
- journal article
- review article
- Published by EDP Sciences in Manufacturing Review
- Vol. 6, 19
Abstract
For mechanical machining the quality of cutting-tool materials is one of the most significant issues that need to be addressed. Enhancement of cutting tool performance may be achieved through the use of modern composition ceramic cutting tools This may be enabled through surface treatment, and also hot pressing and spark plasma sintering – the two main processes used for manufacturing such tools. In this article the advantages and disadvantages of the technologies and processes involved are analyzed and compared to identify the most appropriate methods for creating ceramic cutting-tools. In parallel the latest improvements in ceramic cutting-tool materials are reviewed. The paper shows that the choice of ceramic cutting tools is a quite complex process with a number of important factors to be taken into account.Keywords
This publication has 129 references indexed in Scilit:
- Tribological properties of Si3N4–graphene nanocompositesJournal of the European Ceramic Society, 2013
- Study of the mechanical properties, strengthening and toughening mechanisms of Al2O3/TiC micro-nano-composite ceramic tool materialMaterials Science and Engineering: A, 2013
- Effects of sintering processes on mechanical properties and microstructure of TiB2–TiC+8wt% nano-Ni composite ceramic cutting tool materialMaterials Science and Engineering: A, 2012
- An investigation of surface damage in the high speed turning of Inconel 718 with use of whisker reinforced ceramic toolsJournal of Materials Processing Technology, 2012
- Wear behavior of Al2O3/Ti(C,N)/SiC new ceramic tool material when machining tool steel and cast ironJournal of Materials Processing Technology, 2009
- Fabrication and mechanical properties of nano-/micro-sized Al2O3/SiC compositesMaterials Science and Engineering: A, 2009
- Development of Al2O3–SiC composite tool for machining applicationCeramics International, 2004
- Comparison of the tool life of tungsten carbides coated by multi-layer TiCN and TiAlCN for end mills using the Taguchi methodJournal of Materials Processing Technology, 2002
- Three and five axes milling of sculptured surfacesJournal of Materials Processing Technology, 2000
- Ceramic cutting tool materialsMaterials & Design (1980-2015), 1986