36.6 A 112Gb/s 0.61pJ/b PAM-4 Linear TIA Supporting Extended PD-TIA Reach in 28nm CMOS

Authors:

Abstract
The growing demand for cloud storage and artificial intelligence applications pushes optical communications to higher data rates and lower cost. Co-packaging the PD, BiCMOS TIA, and CMOS switch ASIC on the same substrate can effectively improve signal integrity and reduce power consumption, improving integration density and reducing the cost [1]–[2]. Integrating the TIA into the switch ASIC in CMOS can further reduce the total component counts, achieving lower cost and power consumption [3], as shown in Fig. 36.6.1 (top left). A reasonable distance from the PD to TIA+ASIC is needed to circumvent the constraints of the ASIC thermal expansion, the optical coupling flexibility, the mechanical stability, and field replacement caused by short PD-TIA reach, as shown in the table of Fig. 36.6.1 (middle left). A PD-TIA reach of 0.2inch is confirmed to be adequate through industry trial and error. However, extending PO- TIA reach leads to increased signal reflection, induces in-band amplitude un-flatness, and deteriorates bandwidth. Previous works [3]–[4] have sought to address these issues by scaling the characteristic impedance of the interconnect lines and introducing damping resistors. However, these approaches only support a maximum PD-TIA reach of 0.03inch [4]. This paper presents a 4×112Gb/s PAM-4 TIA with active-input-termination TIA (AIT-TIA) and signal-interpolation-based single-ended-to-differential convertor (S2D), supporting a 0.2inch PD-TIA reach with a 0.61 pJ/b power efficiency.