NSHT: New Smart Hybrid Transducer for Structural and Geotechnical Applications
Authors:
Open Access
- 29 June 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (13) , 4498
Abstract
This work describes the application of a new transducer prototype for continuous monitoring in both the structural and geotechnical fields. The transducer is synthetically constituted by a wire of optical fiber embedded between two fiber tapes (fiberglass or carbon fiber) and glued by a matrix of polyester resin. The fiber optical wire ends have been connected to a control unit whose detection system is based on Brillouin optical time-domain frequency analysis. Three laboratory tests were carried out to evaluate the sensor’s reliability and accuracy. In each experiment, the transducer was applied to a sample of inclinometer casing sets in different configurations and with different constraint conditions. The experimental collected data were compared with theoretical models and with data obtained from the use of different measuring instruments to perform validation and calibration of the transducer at the same time. Several diagrams can compare the transducer and highlight its suitability for the monitoring and maintenance of structures. The characteristic of the transducer suggests its use as a mixed system for reinforcing and monitoring, especially in the lifetime maintenance of critical infrastructures such as transportation and service networks, and historical heritage.Keywords
Funding Information
- Università degli Studi della Campania Luigi Vanvitelli (Programma VALERE: “VAnviteLli pEr la RicErca”, DDG n. 516 – 24/05/2018)
This publication has 55 references indexed in Scilit:
- Intelligent health monitoring of aerospace composite structures based on dynamic strain measurementsExpert Systems with Applications, 2012
- A "simulation chain" to define a Multidisciplinary Decision Support System for landslide risk management in pyroclastic soilsNatural Hazards and Earth System Sciences, 2012
- Vibration-based damage detection in an aircraft wing scaled model using principal component analysis and pattern recognitionJournal of Sound and Vibration, 2008
- Investigation into the use of low cost MEMS accelerometers for vibration based damage detectionComposite Structures, 2008
- Postfailure Mechanics of Landslides: Laboratory Investigation of Flowslides in Pyroclastic SoilsJournal of Geotechnical and Geoenvironmental Engineering, 2007
- Identification of defects and strain error estimation for bending steel beams using time domain Brillouin distributed optical fiber sensorsSmart Materials and Structures, 2006
- Damage detection in bending beams through Brillouin distributed optic-fibre sensorBridge Structures, 2005
- Aircraft composites assessment by means of transient thermal NDTProgress in Aerospace Sciences, 2004
- The Potential for Earthquake Early Warning in Southern CaliforniaScience, 2003
- Experimental and numerical studies of geosynthetic-reinforced sand slopes loaded with a footingCanadian Geotechnical Journal, 2000