TiO2/Solid State Polymer Junction for Photovoltaic Application
Authors:
- 8 October 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 576, 623-625
Abstract
Solid state polymer electrolyte blend of polyethylene oxide, chitosan, ammonium iodide, and iodine crystals has been prepared by solution cast technique. The highest ionic conductivity of the polymer electrolyte was 1.18 × 10−5 S cm−1 at room temperature. Addition of chitosan to the electrolyte has improved its mechanical properties. A photovoltaic junction with configuration ITO/TiO2-solid state polymer blend electrolyte/ITO has been constructed. The open circuit voltage Voc, short circuit current density Jsc, and fill factor FF% obtained from the photovoltaic system under white light illumination of 100W Tungsten lamp are 320-350 mV, 0.59-2.5μAcm-2 and 42%-59% respectively.Keywords
This publication has 5 references indexed in Scilit:
- Fabrication of Quasi-solid-state Dye-sensitized TiO2 Solar Cells Using Low Molecular Weight GelatorsChemistry Letters, 1998
- A dye sensitized TiO2 photoelectrochemical cell constructed with polymer solid electrolyteSolid State Ionics, 1996
- A dye-sensitized nano-porous solid-state photovoltaic cellSemiconductor Science and Technology, 1995
- A Solid State, Dye Sensitized Photoelectrochemical CellThe Journal of Physical Chemistry, 1995
- A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 filmsNature, 1991