Experimental Study on Bearing Characteristics of Pile-Anchor Foundations for Floating Offshore Wind Turbines Under Inclined Loading
Open Access
- 2 October 2025
- journal article
- research article
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 13 (10) , 1890
Abstract
Pile-anchor foundations, serving as one of the anchoring solutions to ensure the safety and stability of floating offshore wind turbines, are primarily subjected to inclined loading induced by anchor chain forces, resulting in significantly different bearing behavior compared to conventional vertically loaded pile foundations. However, experimental research on the inclined pullout performance of anchor piles remains insufficient. To address this gap, this study employs a self-developed servo-controlled loading system to investigate the pullout bearing characteristics of anchor piles in dry and saturated sand, considering factors such as pullout angle and loading point depth. The research results show that from the load–displacement curve of the model pile, it can be found that with the increase in displacement, the load it bears first gradually increases to the peak, then decreases, and then gradually stabilizes. The loading angle has a significant impact on the bearing performance of pile-anchor foundations. As the loading angle increases, the failure mode shows pullout failure. When the loading angle increases from 30° to 60°, the bearing performance of the pile foundation decreases by approximately 63%. When the depth of the loading point increases from 0.22 times the pile length to 0.78 times the pile length, the diagonal anchor tensile bearing capacity of the model pile increases by approximately 45%. When the depth of the loading point is the same, the distribution patterns of bending moment and shear force are basically similar. However, the smaller the loading angle, the larger the value. This is because the horizontal load component plays a dominant role. The compression of the piles above and below the loading point, as well as the bending moment, shear force and axial force under saturated sand conditions, are similar to those in dry sand, but their values are reduced by about 50%. It can be seen that the soil conditions have an influence on the bearing characteristics of pile foundations.Keywords
Funding Information
- National Natural Science Foundation of China Youth Science Fund Project (52201324)
- CCCC Highway Consultants Co., Ltd. “Unveiling List and Assuming Command” Program for Key Technology R&D Program (2023-ZJKJ-01)
- Research on Key Technologies of Far-reaching Offshore Wind Power (SW-2023-039)
This publication has 37 references indexed in Scilit:
- Pore water pressure of clay soil around large-diameter open-ended thin-walled pile (LOTP) during impact penetrationComputers and Geotechnics, 2025
- Investigation of the soil deformation around laterally loaded deep foundations with large diametersActa Geotechnica, 2023
- Experimental comparison of a dual-spar floating wind farm with shared mooring against a single floating wind turbine under wave conditionsEngineering Structures, 2023
- Set-up effect of large-diameter open-ended thin-walled pipe piles driven in clayComputers and Geotechnics, 2023
- Experimental studies on the behavior of a single shaped pile under oblique pullout loadsActa Geotechnica, 2023
- Analytical solutions of soil plug behaviors in open-ended pile driven by impact loadActa Geotechnica, 2023
- Soil Resistance during Driving of Offshore Large-Diameter Open-Ended Thin-Wall Pipe Piles Driven into Clay by Impact HammersComputers and Geotechnics, 2022
- Experimental study on the mechanical behaviors and particle breakage characteristics of calcareous sand from South China Sea under repeated one-dimensional impactsActa Geotechnica, 2022
- Modeling oblique load carrying capacity of batter pile groups using neural network, random forest regression and M5 model treeFrontiers of Structural and Civil Engineering, 2018
- Modelling the load–deformation response of deep foundations under oblique loadingEnvironmental Modelling & Software, 2006