Study on the Meso‐Energy Damage Evolution Mechanism of Single‐Joint Sandstone under Uniaxial and Biaxial Compression
Open Access
- 1 January 2021
- journal article
- research article
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2021 (1)
Abstract
Energy conversion and release occur through the entire deformation and failure process in jointed rock masses, and the accumulation and dissipation of rock mass energy in engineering can reveal the entire process of deformation and instability. This study uses PFC2D to carry out numerical simulation tests on single‐joint sandstone under uniaxial compression and biaxial compression, respectively, and analyse the influence of joint inclination, length, and confining pressure on the meso‐energy conversion process and phase evolution of jointed sandstone. Through analysis, it is found that the input meso total strain energy is transformed into meso dissipated energy and meso‐elastic strain energy. Macroscopic and microscopic joint sandstone law is consistent with the overall energy evolution; and the difference is reflected in two aspects: (1) the microlevel energy evolution has no initial compaction energy consumption section and (2) the linear energy storage section before the macroenergy evolution peak can be subdivided into two sections in the meso‐level energy evolution. Under uniaxial compression, the energy values at the characteristic points of the meso‐level energy evolution phases first asymmetrically decrease and then increase with the increase of the joint inclination. The initiation point of jointed sandstone is significantly affected by the length of the joint, and the degradation effect of the meso‐energy at the damage point and peak point weakens with the increase of the joint length. Comparing the data obtained from the PFC numerical simulation with the experimental data, it is found that the error is small, which shows the feasibility of the numerical model in this paper. Under biaxial compression, the accumulation rate of meso‐elastic strain at the peak point of the jointed sandstone first decreases and then increases with the joint inclination angle. After the peak of jointed sandstone, the rate of sudden change of meso‐energy change decreases with the increase of joint length. The conditions of high confining pressure will promote the meso‐accumulated damage degree of the jointed sandstone before the peak, while inhibiting the meso‐energy and the mutation degree of the damage after the peak. The higher the confining pressure, the more obvious the joint length and inclination effect characteristics of the elastic strain energy at the peak point of the jointed sandstone.Keywords
Funding Information
- National Natural Science Foundation of China (51978106)
This publication has 27 references indexed in Scilit:
- Experimental investigation on the energy evolution of dry and water-saturated red sandstonesInternational Journal of Mining Science and Technology, 2015
- Energy Dissipation and Release During Coal Failure Under Conventional Triaxial CompressionRock Mechanics and Rock Engineering, 2014
- Conversion of strain energy in Triaxial Unloading Tests on MarbleInternational Journal of Rock Mechanics and Mining Sciences, 2014
- A numerical study of rock burst development and strain energy releaseInternational Journal of Mining Science and Technology, 2012
- Crack Coalescence in Molded Gypsum and Carrara Marble: Part 2—Microscopic Observations and InterpretationRock Mechanics and Rock Engineering, 2008
- Triaxial compressive behavior of rock with mesoscopic heterogenous behavior: Strain energy density factor approachTheoretical and Applied Fracture Mechanics, 2006
- A bonded-particle model for rockInternational Journal of Rock Mechanics and Mining Sciences, 2004
- On the coupling of anisotropic damage and plasticity models for ductile materialsInternational Journal of Solids and Structures, 2003
- Rock failure due to energy release during unloading and application to underground rock burst controlTunnelling and Underground Space Technology, 2001
- Sensitivity of sandstone strength and deformability to changes in moisture contentQuarterly Journal of Engineering Geology, 1992