Mechanical Properties of Steel-FRP Composite Bars (SFCBs) and Performance of SFCB Reinforced Concrete Structures
Authors:
- 1 April 2012
- journal article
- research article
- Published by SAGE Publications in Advances in Structural Engineering
- Vol. 15 (4) , 625-635
Abstract
A steel-fiber reinforced polymer (FRP) composite bar (SFCB) is a novel reinforcing rebar made of an inner steel bar and outer FRP integrated in a pultrusion process. To promote the application of this new reinforcing rebar, this paper explores the mechanical properties of SFCBs and the performance of SFCB-reinforced concrete structures. Test results of SFCBs under uniaxial and cyclic tensile loading show that SFCB has a high elastic modulus, a stable post-yield modulus and a high ultimate strength. The tensile characteristics of SFCBs calculated according to the mixture law are found to be in good agreement with test results. A direct pullout test between SFCBs and concrete was conducted. The failure modes included SFCB pullout before or after inner steel bar yielded, which depended on factors like the steel/FRP ratio, effective bond length, and concrete strength. With its high-performance, especially with regard to anti-corrosion, and low cost, SFCBs are an ideal near-surface mounted (NSM) material to strengthen concrete beams. Experimental results show that NSM-SFCB strengthening can significantly increase both the section stiffness of the flexural members in the service stage and the bearing capacity in the ultimate stage. Concrete columns reinforced by SFCBs under horizontal cyclic loading were also tested, and the results show that concrete columns reinforced by SFCBs possess high initial stiffness, acceptable bearing capacity and good ductility. More importantly, SFCB columns had an obvious post-yield stiffness, which resulted in smaller residual displacement and, therefore, better post-earthquake reparability.Keywords
This publication has 13 references indexed in Scilit:
- Hybrid FRP–concrete–steel tubular columns: Concept and behaviorConstruction and Building Materials, 2007
- Near-surface mounted FRP reinforcement: An emerging technique for strengthening structuresComposites Part B: Engineering, 2007
- Generic Debonding Resistance of EB and NSM Plate-to-Concrete JointsJournal of Composites for Construction, 2007
- Strength and ductility of concrete cylinders confined with FRP compositesConstruction and Building Materials, 2006
- TWO-LEVEL SEISMIC DESIGN METHOD USING POST-YIELD STIFFNESS AND ITS APPLICATION TO UNBONDED BAR REINFORCED CONCRETE PIERSSTRUCTURAL ENGINEERING / EARTHQUAKE ENGINEERING, 2006
- Performance of hybrid rebars as longitudinal reinforcement in normal strength concreteMaterials and Structures, 2005
- Cyclic Response of Unbonded Posttensioned Precast Columns with Ductile Fiber-Reinforced ConcreteJournal of Bridge Engineering, 2004
- PERFORMANCE-BASED SEISMIC RESPONSE OF FRAME STRUCTURES INCLUDING RESIDUAL DEFORMATIONS. PART I: SINGLE-DEGREE OF FREEDOM SYSTEMSJournal of Earthquake Engineering, 2003
- New Ductile Hybrid FRP Reinforcing Bar for Concrete StructuresJournal of Composites for Construction, 1998
- Tensile properties of hybrid rods for concrete reinforcementConstruction and Building Materials, 1994