Study on Gap Flow Field Simulation in Small Hole Machining of Ultrasonic Assisted EDM
Open Access
- 20 December 2017
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 280 (1) , 012009
Abstract
When machining a small hole with high aspect ratio in EDM, it is hard for the flushing liquid entering the bottom gap and the debris could hardly be removed, which results in the accumulation of debris and affects the machining efficiency and machining accuracy. The assisted ultrasonic vibration can improve the removal of debris in the gap. Based on dynamics simulation software Fluent, a 3D model of debris movement in the gap flow field of EDM small hole machining assisted with side flushing and ultrasonic vibration is established in this paper. When depth to ratio is 3, the laws of different amplitudes and frequencies on debris distribution and removal are quantitatively analysed. The research results show that periodic ultrasonic vibration can promote the movement of debris, which is beneficial to the removal of debris in the machining gap. Compared to traditional small hole machining in EDM, the debris in the machining gap is greatly reduced, which ensures the stability of machining process and improves the machining efficiency.Keywords
This publication has 5 references indexed in Scilit:
- Modeling Debris Motion in Vibration Assisted Reverse Micro Electrical Discharge Machining Process (R-MEDM)Journal of Microelectromechanical Systems, 2014
- Analysis of the effect of vibrations on the micro-EDM process at the workpiece surfacePrecision Engineering, 2011
- Simulation of Debris Movement in Micro Electrical Discharge Machining of Deep HolesMaterials Science Forum, 2009
- Investigation of electro-discharge micro-machining of titanium super alloyThe International Journal of Advanced Manufacturing Technology, 2008
- Local actuator module for highly accurate micro-EDMJournal of Materials Processing Technology, 2004