Plasma-enhanced and thermal atomic layer deposition of Al2O3 using dimethylaluminum isopropoxide, [Al(CH3)2(μ-OiPr)]2, as an alternative aluminum precursor
- 17 February 2012
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 30 (2) , 021505
Abstract
The authors have been investigating the use of [Al(CH3)2(μ-OiPr)]2 (DMAI) as an alternative Al precursor to [Al(CH3)3] (TMA) for remote plasma-enhanced and thermal ALD over wide temperature ranges of 25–400 and 100–400 °C, respectively. The growth per cycle (GPC) obtained using in situ spectroscopic ellipsometry for plasma-enhanced ALD was 0.7–0.9 Å/cycle, generally lower than the >0.9 Å/cycle afforded by TMA. In contrast, the thermal process gave a higher GPC than TMA above 250 °C, but below this temperature, the GPC decreased rapidly with decreasing temperature. Quadrupole mass spectrometry data confirmed that both CH4 and HOiPr were formed during the DMAI dose for both the plasma-enhanced and thermal processes. CH4 and HOiPr were also formed during the H2O dose but combustion-like products (CO2 and H2O) were observed during the O2 plasma dose. Rutherford backscattering spectrometry showed that, for temperatures >100 °C and >200 °C for plasma-enhanced and thermal ALD, respectively, films from DMAI had an O/Al ratio of 1.5–1.6, a H content of ∼5 at. % and mass densities of 2.7–3.0 g cm−3. The film compositions afforded from DMAI were comparable to those from TMA at deposition temperatures ≥150 °C. At lower temperatures, there were differences in O, H, and C incorporation. 30 nm thick Al2O3 films from the plasma-enhanced ALD of DMAI were found to passivate n- and p-type Si floatzone wafers (∼3.5 and ∼2 Ω cm, respectively) with effective carrier lifetimes comparable to those obtained using TMA. Surface recombination velocities of < 3 and < 6 cm s−1 were obtained for the n- and p-type Si, respectively. Using these results, the film properties obtained using DMAI and TMA are compared and the mechanisms for the plasma-enhanced and thermal ALD using DMAI are discussed.Keywords
This publication has 84 references indexed in Scilit:
- Physical and electrical characterizations of metal-oxide-semiconductor capacitors fabricated on GaAs substrates with different surface chemical treatments and Al2O3 gate dielectricJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2009
- Very low surface recombination velocity on p-type c-Si by high-rate plasma-deposited aluminum oxideApplied Physics Letters, 2009
- Effective surface passivation of crystalline silicon by rf sputtered aluminum oxidePhysica Status Solidi (RRL) – Rapid Research Letters, 2009
- In situspectroscopic ellipsometry as a versatile tool for studying atomic layer depositionJournal of Physics D: Applied Physics, 2009
- Very low-pressure VLP-CVD growth of high quality γ-Al2O3 films on silicon by multi-step processJournal of Crystal Growth, 2002
- Low temperature surface passivation for silicon solar cellsSolar Energy Materials and Solar Cells, 1996
- Ultrafine aluminum oxide powder prepared by chemical vapor deposition of trimethylaluminumJournal of Materials Engineering, 1991
- Low-Temperature Growth of Thin Films of Al2O3 by Sequential Surface Chemical Reaction of trimethylaluminum and H2O2Japanese Journal of Applied Physics, 1991
- Crystal structure of trimethylaluminumJournal of the American Chemical Society, 1967
- The Alkyls of the Third Group Elements. I. Vapor Phase Studies of the Alkyls of Aluminum, Gallium and Indium1Journal of the American Chemical Society, 1941