The Effect of Oxygen Partial Pressure on Heat Transfer and Solidification
Authors:
- 1 January 2006
- journal article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 46 (10) , 1427-1431
Abstract
The effect of oxygen partial pressure (PO2) in different gas atmospheres on heat transfer, cast structure and secondary dendrite arm spacing in droplet solidification process has been investigated. It has been found that the PO2 of the gas affects solidification process and undercooling. As PO2 decreases, at relatively high PO2 (10−1.2–10−4) in 99.99% Ar and air atmosphere, heat flux is decreased and equiaxed zone ratio and secondary arm spacing are found to be increased. At intermediate PO2 (10−14 to 10−20) in Ar–H2 atmospheres, heat flux and equiaxed zone ratio varies only slightly and secondary arm spacing is reduced. At low PO2 (10−20–10−23) in Ar–5%H2 atmosphere, heat flux increases dramatically and the equiaxed zone ratio and secondary arm spacing are reduced. The largest equiaxed zone is found with intermediate PO2 levels in Ar–H2 gas atmospheres, whereas the finest grains are obtained in Ar–5%H2 gas in low PO2 value.Keywords
This publication has 3 references indexed in Scilit:
- Recent progress on commercialization of castrip direct strip casting technology at Nucor CrawfordsvilleMetallurgist, 2004
- Analysis and prevention of cracking during strip casting of AISI 304 stainless steelMetallurgical and Materials Transactions A, 2001
- Experimental Studies of Interfacial Heat Transfer and Initial Solidification Pertinent to Strip Casting.ISIJ International, 1998