Dynamic Response Mechanism of Thin-Walled Plate under Confined and Unconfined Blast Loads
Top Cited Papers
Open Access
- 26 January 2024
- journal article
- research article
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 12 (2) , 224
Abstract
Thin-walled metal plates and cabin structures are widely found in ships and cargos which are susceptible to attacks or accidental explosions. The present work focuses on the dynamic response mechanism of steel plates under unconfined and confined blast loads. In the experiment, digital image correlation (DIC) technique was applied to record and analyze the dynamic response process of a large-scale field blast test. The DIC measured curve and the numerically calculated curves agree well in both trends and peak values. Then, the dynamic response mechanisms of steel plates under an unconfined blast (UB) load and confined blast (CB) load were compared and discussed. The results show that the dynamic response of plates can be divided into three phases under both UB and CB loads, with different mechanisms. In phase I, plastic hinges start from the center and move to the boundary in the UB condition, while in the case of CB, plastic hinges occur close to the boundary and move in the opposite direction. In phase II, two plastic hinge lines propagate towards each other, a platform exists between the boundary, and the central area remains undeformed in the UB condition, while in the CB condition, larger deformation occurs in the peripheral region rather than the central area.Keywords
Funding Information
- National Natural Science Foundation of China (12272414, 11972371, 11902369, 2021JJ30786, 2023RC3045)
- Natural Science Foundation of Hunan Province (12272414, 11972371, 11902369, 2021JJ30786, 2023RC3045)
- Science and Technology Innovation Plan of Hunan Province (12272414, 11972371, 11902369, 2021JJ30786, 2023RC3045)
This publication has 42 references indexed in Scilit:
- Effect of plate curvature on blast response of aluminum panelsInternational Journal of Impact Engineering, 2012
- Failure mechanisms in composite panels subjected to underwater impulsive loadsJournal of the Mechanics and Physics of Solids, 2011
- A brief note on the counter-intuitive region of a square plateInternational Journal of Impact Engineering, 2011
- The analysis and simulation of welded stiffener plates subjected to localised blast loadingInternational Journal of Impact Engineering, 2010
- Application of 3D image correlation for full-field transient plate deformation measurements during blast loadingInternational Journal of Impact Engineering, 2009
- The effect of stand-off distance on the failure of fully clamped circular mild steel plates subjected to blast loadsEngineering Structures, 2007
- On the influence of constitutive relation in projectile impact of steel platesInternational Journal of Impact Engineering, 2007
- Experimental and numerical studies on the response of quadrangular stiffened plates. Part I: subjected to uniform blast loadInternational Journal of Impact Engineering, 2005
- The deformation and tearing of thin square plates subjected to impulsive loads—An experimental studyInternational Journal of Impact Engineering, 1996
- Deformation and tearing of blast-loaded stiffened square platesInternational Journal of Impact Engineering, 1995