Single-step synthesis of nano-sized perovskite-type oxide/carbon nanotube composites and their electrocatalytic oxygen-reduction activities
- 30 November 2010
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry
- Vol. 21 (6) , 1913-1917
Abstract
Composites of nano-sized perovskite-type oxides of La1−xSrxMnO3 (LSMO) and carbon nanotubes (CNTs) were synthesized in a single step by the electrospray pyrolysis method, and their electrocatalytic activities for oxygen reduction were evaluated in an alkaline solution. The resulting LSMO nanoparticles with a diameter of less than 20 nm were well dispersed and deposited on the surface of CNTs. Elemental analysis showed that the metal-composition of LSMO/CNT composites was controlled by altering the concentrations of a precursor solution. Rotating-disk-electrode measurements revealed that the electrocatalytic activities of LSMO/CNT composites increased with an increase in a molar ratio of Sr element. Composites of LSMO nanoparticles and CNTs showed greater catalytic activities than conventional LSMO particles (1 µm) supported on carbon black for oxygen reduction. Moreover the LSMO/CNT catalyst showed larger oxygen-reduction currents even in the presence of ethylene glycol while a Pt disk electrode was affected by the oxidation currents of ethylene glycol. These results indicate that LSMO/CNT composites are a promising candidate as a cathode catalyst with a higher catalytic selectivity for oxygen reduction and a higher crossover-tolerance for use in anion-exchange membrane fuel cells.Keywords
This publication has 21 references indexed in Scilit:
- Thermal Stability, Vapor Pressures, and Diffusion Coefficients of Some Metal 2,2,6,6-Tetramethyl-3,5-heptandionate [M(tmhd)n] CompoundsJournal of Chemical & Engineering Data, 2010
- Single-Step Synthesis of Nanosized Titanium-Based Oxide/Carbon Nanotube Composites by Electrospray Deposition and Their Electrochemical PropertiesThe Journal of Physical Chemistry C, 2009
- Perovskite-type oxides La1−xSrxMnO3 for cathode catalysts in direct ethylene glycol alkaline fuel cellsJournal of Power Sources, 2008
- Electrochemical Insertion and Extraction of Lithium Ion at Uniform Nanosized Li4/3Ti5/3O4 Particles Prepared by a Spray Pyrolysis MethodChemistry of Materials, 2005
- Anodic Oxidation of Polyhydric Alcohols on a Pt Electrode in Alkaline SolutionFuel Cells, 2002
- Preparation and Characterization of Platinum-Based Electrocatalysts on Multiwalled Carbon Nanotubes for Proton Exchange Membrane Fuel CellsLangmuir, 2002
- Ln1-xAxCoO3 (Ln = Er, La; A = Ca, Sr)/Carbon Nanotube Composite Materials Applied for Rechargeable Zn/Air BatteriesChemistry of Materials, 2002
- Metallic oxidesProgress in Solid State Chemistry, 1971
- Low-cost Oxygen Electrode MaterialNature, 1970
- Electrical conductivity of ferromagnetic compounds of manganese with perovskite structurePhysica, 1950